is this my next step

[Ben j]

i have a full stainless system with de-cat, cold forced air feeded induction kit, ekotek, hill power chip....
is a power boost valve worth doing next?

 

[BRUN]

well when Nick chipped your car, have you done any other mods after that ?

what did his Lumenition show about the fuelling, on mine it was spot on

if you get one, make sure you have it setup properly

 

[Nick Read]

Ben - Id say get an air/fuel ratio meter first, then if it looks like its going too lean or rich on full throttle, then get a pbv so you can adjust your fuelling.

 

[Ben j]

ive just had a new lamba sensor fitted and an mot, think he said its fuelling fine though, just wondered whats next

 

[Nick Read]

Yeah but theres not much point in getting an adjustable fuel pressure regulator if you cant see what youre adjusting and just guess!

 

[Ben j]

where can i get a decent one from then?
presumablt it only needs a +, - and a tap into te signal cable from the lamba sensor? is that right?

 

[Ben j]

or am i thinking of something different?