KTR/Janspeed Ultra - Not out far enough?

[MDP91]

So I've had my Janspeed ultra with decat fitted for a couple of months now and I'm loving it, one thing after fitting that I have noticed and we just couldn't seem to get right is that the tail pipes don't seem to come out far enough? They do poke out but the engraving on the tips is just under the exhaust cut outs? When we try to give the system some extra length it leave slight gaps where the sleeves are so I can't win. Anyone had this issue? It fits perfectly other than that. I'll try and get some pics up tomorrow.

 

[Russ_16v]

Pic will be good dude, are you happy with how it sits?

 

[MDP91]

Pic will be good dude, are you happy with how it sits?

Well I am kind of, would like it to poke out a little more though. Here's a pic I took showing my badge yesterday but you can see the exhaust, looks slightly off because its taken at an angle but you get the idea.

 

[Jacko90]

Could try loosening your engine mounts and pushing the engine backwards and tightening them. Might make a few millimetres difference.

 

[MDP91]

Could try loosening your engine mounts and pushing the engine backwards and tightening them. Might make a few millimetres difference.

Not a bad idea that, not something ive ever done before though, easy enough to do?

 

[Dan519]

Could try loosening your engine mounts and pushing the engine backwards and tightening them. Might make a few millimetres difference.

more likely to reveal play in the upper engine mount, which most people pull the engine forward to stop

 

[jesus]

Looks fine to me. You can adjust your bumper by unscrewing the screws that hold the tab underneath the bumper (inside), pulling it towards the car and tightening up again. Sorry I can't be any more descriptive!

 

[MDP91]

Looks fine to me. You can adjust your bumper by unscrewing the screws that hold the tab underneath the bumper (inside), pulling it towards the car and tightening up again. Sorry I can't be any more descriptive!

Little unsure what you mean but I shall take a look

 

[MartinR]

Looks fine to me. You can adjust your bumper by unscrewing the screws that hold the tab underneath the bumper (inside), pushing it towards the car and tightening up again

^^^This

 

[chriscummins7]

I think it looks spot on as it is mate.

Could you do a vid of the exhaust? I have the unsilenced ultra, thinking about a decat too but not too sure!

 

[Shifty.]

I have the same exhaust and that's how mine sits, personally I don't really want it poking out any further.

 

[Silent_Scone]

Looks spot on tbh

 

[MDP91]

My just leave it if people think it looks fine then, just assumed it was meant to stick out a little more that's all.

 

[MDP91]

I think it looks spot on as it is mate.

Could you do a vid of the exhaust? I have the unsilenced ultra, thinking about a decat too but not too sure!

Ive got a couple of vids but they are s**t so i'll try and get another asap. Is sounds good with a decat, but I'm not going to lie, its bloody loud!

 

[Ian_s]

When I bought my car the exhaust was sticking out far enough to see all of the Janspeed logo. I spent many hours of swearing trying to get it to fit further in (moved about 5mm) before I realised about the bumper.

 

[MDP91]

so how do I adjust the bumper? when I look up from underneath right I loosen the part that hold it to the frame and push it in??