matched inlets?

[joeseph]

Anybody know best place to get inlets matched in leeds/yorkshire area?

 

[Mr R.]

Andrew @ ALD is in Leeds.

http://www.aldevelopments.com/

 

[JonC219]

I can vouch for Andrews work. Had my upper and lower inlets matched to the gaskets and each other. Feels a lot more responsive lower down the revs to be honest. Top end I havent felt a change but thats not to say there hasnt been.

No RR results though...yet.

 

[Mr R.]

Andrew will be doing my head.

His already done Ph1 Tom head with good results

 

[Ph1 Tom]

Had my head and inlets done with good results.

 

[joeseph]

Sounds good Andrew, ive send you a private message before seeing this. I'll be in touch.

 

[Ocrlew]

i want some matching too, how much do you charge?

 

[Jakey92]

Is it worth the hassle on a standard engine? (head work and ported inlet)

Had my head and inlets done with good results.

How much did that cost?

 

[Mr R.]

Ive had mine done but the Ph1 port's are alot smaller than the ph2.
The RS lower is better but there is still room for improvement.

Every little helps as they say.

 

[Mr-darren]

Does anyone know if there is someone around the Swansea area that will match my inlets?

 

[VikkiB]

No point on a 182 as you'll have RS Stamped inlets.

 

[Chip-mk1]

No point on a 182 as you'll have RS Stamped inlets.

Yeah it makes the gains even smaller.

 

[Jakey92]

Yeah it makes the gains even smaller.

I assume this isn't the case with head work?

 

[Chip-mk1]

I assume this isn't the case with head work?

I'm of the opinion headwork is a waste of time on these cars unless on cams and bodies tbh. Lots of hassle for small gains on a fairly standard engine