Rear disc bearing stuck

[Bobie8]

Finally got my hands on a disc puller and its removed the disc but left half the bearing on the stub. Any tips on getting the rest of it off?

Cheers

 

[Jewson172]

I just used a small hammer and lots of grease on the stub axel to lightly tap it till it gets to the thinner part of the stub, then it should come off easy.

 

[Tony Hunter]

Warm the bearing up with a blow torch to make it bigger,then knock it off.

 

[mr.pink87]

Don't forget the deflector shims on reassembly!

 

[craigy2703]

Puller? I used a big hammer lol half of mine got stuck I found if you tap it back on a bit wi a hammer and screwdriver then tap it off it came straight off

 

[Bobie8]

Hmmmm not having much success with the hammer and screw driver approach. Gonna use fire for the next attempt, anyway to get a better angle im comming in at more than 90 degrees trying to get behind the bearing?

 

[-J-]

Had the same issue with a bearing i did on Stuntys car on here...

Issue was resoved with a BIG Hammer and a BIG Screwdriver, took some beating into submission to remove it though!

 

[scotty2hotty81]

And if all the above fails, find someone who is confident with a grinder, cut into it on opposite sides and hit it in one of the cuts with a big chisel and a hammer and it will fracture and fall off.

 

[easym5]

And if all the above fails, find someone who is confident with a grinder, cut into it on opposite sides and hit it in one of the cuts with a big chisel and a hammer and it will fracture and fall off.

I have had to do this on the last 2 ive repaired as the heat didnt work,be very careful though

 

[Martin_172]

Don't forget the deflector shims on reassembly!

keep this in mind, cost arnold clark £800 to repair our 1.6 16v after forgetting these on the rear discs!

 

[mr.pink87]

New stub axle time?