Rubber Support on Exhaust

[Christophe]

Mines collapsed and wanted to know if it's easy to fit? My car at the garage on friday getting braided brake lines fitted with new brake fluid etc and thought i could get them to fit it . Will it take them long ?

i assume this will fit ok? I have a powerflow exhaust system

http://cgi.ebay.co.uk/Renault-Clio-...3|66:2|65:12|39:1|240:1318|301:1|293:1|294:50

 

[Greeny.]

Powerflow sometimes tend not to use the standard mounts tbh, I know my old one didnt use the standard rear one.

 

[Sargara]

Mine is supported by resting on a peice of pipe which was rammed into the mount under the middle bit and cable tied in place. Sorted

 

[shiyan]

Mine is supported by resting on a peice of pipe which was rammed into the mount under the middle bit and cable tied in place. Sorted

ditto

I noticed the "legs" tearing, asked someone to hold up the suspension while I shoved a section of rubber pipe in the gap, decided it still wasn't strong enough, so I shoved another piece of rubber inside the rubber pipe. Tied the whole thing in place with zipties.

 

[Sjdickso]

Mine is supported by resting on a peice of pipe which was rammed into the mount under the middle bit and cable tied in place. Sorted

I did exactly the same to mine yesterday.