Spacers

[Barron]

Looking for some 15mm hubcentric spacers for the track car. I will be using extended bolts so dont want ones that bolt to the hub.

wheres the cheapest place for them?

thanks
carl

 

[Sam]

convert to studs karl.

 

[Barron]

its CARL not karl, karl is the poor mans way of spelling it.

anyway i am going to do that, website link to yours?

ta
carl

 

[Hutchie]

its CARL not karl, karl is the poor mans way of spelling it.

anyway i am going to do that, website link to yours?

ta
carl

sell you a wider front subframe

 

[Fred@BTM]

just changed mine to studs with 13mm hubcentric FK spacers all round

 

[Barron]

where did you get them from fred, and price?

 

[-KarL-]

carl is bent way of spelling it,

ive got some 15mm spacers in my garage

 

[Fred@BTM]

studs and nuts are about £70 (can probably be done cheaper though)

spacers are £45 per axle IIRC

not cheap, but good

 

[Gray]

Out of interest why did you go for 13mm spacers Fred?

 

[Fred@BTM]

because they were the slimmest hubcentrics i could find (i'm running 1.2 arches remember, and its LOW)

 

[Gray]

ahhhh the dynacup

Currently looking for some... what do the cup's run compared to a PH-1

20mm more front track

10mm more rear track

:S

 

[Fred@BTM]

i couldn't tell you off the top of my head, remember phs1's have ET(can't remember) and cups are ET38.5

a cup is 20mm wider on the front and 10mm wider on the rear over a normal phs2 172

 

[Hutchie]

is cup extra track down to wheels or are the beams actually different?

studs and nuta available off www.priracing.com

 

[Gray]

meeeh... may just go 10mm all round!

With a wider track, would that allow you to run more negative camber?

I run 1.5 negative IIRC any more than that scrubs the inside of the tyres on the coilover

 

[Fred@BTM]

172 cups ARE more than just different offset wheels, different rear stub axles for a start