Standard size speakers in rear.

[HiGuys!]

Just wondering wha are the standered speaker size in the back of a clio campus sport as they dont come factory fitted and going to pick up a set of components tomorow. Anyone. Much Apprecito

Thanks

 

[aliengravy]

mines a 1.2 Dynamique and there 13cms! Stick to two way components or singles!! dont use 3 way, your car will lack bass! unless you have a sub like me

 

[Djw John]

Yeah 13 cms-5.25", go for components in the front, same size, and 2 ways in the back. Upgrade the fronts first though!

 

[aliengravy]

if you have a sub, you probably wont need to do rears, but fronts are well wort doing, because i have a sub in the rear, i went for 3 ways up front for the best treble up front and some kick ass bass up back!

 

[Tigger]

Put the components in the front and use the standard speakers in the rear until you can afford to upgrade them

 

[HiGuys!]

yea i got enough to get to sets of components just wondering on what make i should go for. I want sound quality rather than all bass etc. Didnt know wether to go for an all alpine system type R or ive heard Rainbow have good sound quality just bit on the dear side of my budget. mmhm...

 

[Da]

Does the campus have rear speakers? :S

 

[HiGuys!]

nope thats why im getting some. They should be the same size as the front right i messured the front to be 13 cm around there??

 

[Da]

Ah yeah they'll be the same size, just there'll be no cables there!

 

[HiGuys!]

yeah did notice when i took the panels off how come hey dont come as standard?

 

[Da]

It's just down to spec level mate, cost saving at the end of the day!

 

[Tigger]

Alpine Type R speakers are very popular and Iwould say they'll keep you happy
Put coaxils in the back anyway when you do get that far, you only need components in the front.

 

[HiGuys!]

So i am receiving 2 sets of components tomorow and was wondering where the standard crossovers will be in the front. Before i start taking everything apart, was hoping someone could tell me where they are to change with the new one's. Thanks.

Kyle!

 

[bmh.01]

There isn't a crossover on the front as standard, just a filter on the tweeter. Fitting front comps will be fun for you, mainly because theres no easy way to get new cable into the doors.

 

[agithegreat]

There isn't a crossover on the front as standard, just a filter on the tweeter. Fitting front comps will be fun for you, mainly because theres no easy way to get new cable into the doors.

Use existing cables??? Just put filters in before the hinge of the door???
Then new runs to the dash for tweeters...

 

[bmh.01]

Then its pretty permanent when you want too revert to standard to sell. It can be done without chopping anything if you make a few adapters.

 

[agithegreat]

Yeh, fair enough mate
Do a search for front component adapters..... there's loads on here!!!