tdc pin

[L maf]

ive bin told that cus i havent got 1 i cud just use a little drill bit is that true???

also were does it go??

its a phase 1 172

im doin the timing

cheers

 

[mark123]

8mm drill bit, inserted backwards.

The hole is behind a torx bolt on the front of the engine at the flywheel end. Low down to the right of the dip stick.

Check out the manual

http://www.fastchip.nl/media/doc/clio2/F4R_730.pdf

 

[Sean6545]

As above, quite tricky to get too but IS there.

 

[sideways danny]

I'd use an 8mm bolt, a drill bit is quite brittle and could snap if you put any pressure on it