ClioSport.net
Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
-
When you purchase through links on our site, we may earn an affiliate commission. Read more here.
toe convergence
- Thread starter dimo16v
- Start date
182cup & 172 racecar
Shims.
Can't do it on a mk1.
182cup & 172 racecar
Didn't notice that. 
bozothenutter
ClioSport Club Member
you mean more toe out right?
Pretty much your only option on the mk1
OP, The stub axle is built into the beam so unlike a mk2 you cant just unbolt it and put shims behind it.
182cup & 172 racecar
Clio.
Yes you can, I've done it to a R5 GTturbo and my mk1 clio.
Bit of machine work needed though.
Perhaps you can describe to the OP how you did it then? As it sounds like you have the answer to his question.
Clio.
I already did on another forum.
Clio.
In the above link I think the guy used the valver/Williams bracket.
Clio.
Didn't write it up when I did it, one thing I do know is, when using 172/182 stubs and calipers brackets we gained about 5mm extra track on the R5 and used the plastic camber shims that most people use from k-tec not the Pure Motorsport type.
On the same R5 we used clio 1.8 16v discs and willwoods, and squeezed them under 13" compomotive CXR rims, (the regs at the time specified standard diameter wheels, brakes were free).
On the same R5 we used clio 1.8 16v discs and willwoods, and squeezed them under 13" compomotive CXR rims, (the regs at the time specified standard diameter wheels, brakes were free).
Thats interesting, I think I could just about handle an extra 5mm of width on the back of mine as its not too wide to start with anyway.
Would certainly be a real bonus to be able to adjust.
Still building it at the moment though so not had a geo check done yet ,will be interesting to see what I get, it might be close enough that it isnt worth mess or it might be that its well worth the hassle.
There are a lot of different width 172/182 stub axles anyway though, so should be a case of being able to pick a thicker or thinner one to suit anyway once the conversion has been done?
Would certainly be a real bonus to be able to adjust.
Still building it at the moment though so not had a geo check done yet ,will be interesting to see what I get, it might be close enough that it isnt worth mess or it might be that its well worth the hassle.
There are a lot of different width 172/182 stub axles anyway though, so should be a case of being able to pick a thicker or thinner one to suit anyway once the conversion has been done?
Clio.
Give me a shout, as we didn't do it the exactly same way as the French link.
The pink one on the left had the rear beam conversion done to it, but both of them had the bigger brakes.
The pink one on the left had the rear beam conversion done to it, but both of them had the bigger brakes.
Clio.
Big brakes, little wheels
Excuse the fact it only has 2 wheel bolts this was at the mock up stage......
goes well though....
Excuse the fact it only has 2 wheel bolts this was at the mock up stage......
goes well though....
Similar threads
