Torque setting for inlet manifold

[stephen chadwick]

could someone please tell me the torque setting for the inlet manifold

thanks steve

 

[Rob669]

The thread on the bolts are really easy to strip so the torque setting is low. I can find it on dialogys if you wish, but my best advice is to do them up finger tight and then just add a 1/4 turn extra. See if that works, but if there are leaks (the engine revs won't settle if there is an air leak) tighten a little more. In any case I would buy a few extra bolts in case you do strip them - Renault don't charge much for these sort of things.

 

[Ol’ Tarby]

Is it the bolts that strip or is it the thread in the lower inlet that strips as I think I've stripped one of mine.

 

[stephen chadwick]

thanks thats what i did felt around for any air leaks found one so tightened bit more job sorted thanks

 

[hipwell]

Is it the bolts that strip or is it the thread in the lower inlet that strips as I think I've stripped one of mine.

for me it was the thread in the rocker and lower inlet which i ended up nackering lol.

as said dont go mad with em, so easy to strip.

 

[bmh.01]

10nm

 

[Jonny1*2]

10nm

It's 12 isn't it?

 

[bmh.01]

Something like that, near as makes no difference anyway.

edit: 11 +-0.2nm