Torque settings

[MG cup]

Would someone be kind enough to send me a copy of engine and chassis torque settings.

I have most manuals but can't be as**d sifting through manuals just to get torque settings I'm looking for a settings table if the French frogs done such a thing. Most manufacturers do.

Cheers

Morgan

 

[Cupman29]

Unfortunately, the torque settings I have are spread over about 300 or more pages worth of manuals.

 

[MG cup]

It seems I will just have to go through everything and take notes for torques I want, the manuals are the most long winded I have seen, repetitive as fook.

 

[Laine_16v]

What torques are you after specifically?

 

[MG cup]

Mostly engine really, cam cover, cam pulleys, crankshaft pulley, flywheel, sump, manifolds, head bolts, main bearings, big ends

Hub nuts, stub axle and can't think of anything else worth havin really.

 

[Cupman29]

Some of them will be sequential such as the head bolts, cam cover and sump and some will be angular as well such as exhaust cam pulley, crank pulley.

From the ones I have done recently and can remember:
Front Hubs nuts : 280Nm
Rear Hub Nuts : 175Nm
Big Ends : 38Nm
Crankshaft Bolt : 30Nm plus 120deg
Sump : 12-15Nm sequential
Head bolts: 80Nm is used and within stretch.
Inlet Cam : 100Nm
Exhaust Cam : 30Nm plus 86deg
Cam Cover : 12Nm sequential
Flywheel : 55Nm
Exhaust Manifold : 18Nm
Inlet Manifold : 11Nm

 

[MG cup]

Cheers Cupman that lot should keep me going for just now.

 

[Cupman29]

No problem, let me know if you need any more.