Recent content by Clio 1.5 dci

Thanks for the guidance, appreciated. So if I try and code the existing 65BHP injectors, it won't have the same effect as the ones you've linked to? I've come across people selling the Delphi software preloaded onto a cheap laptop - do these also do the job? I've seen them being sold for about...

Interesting, how do I find out my engine code? I don't know if the injectors I got correspond with my engine code, if they're programmed in, will that matter? What clip do you need to do the programming?

How did you know that the injectors you were replacing your OEM ones with were going to offer the same performance? How much was the programming? And was there a difference?

How are they different? Physically they look exactly the same?

Just to also add. I may mix and Match my old 80bhp injectors when I have more time to see if I can simply replace the malfunctioning one than all 4 like I have currently done

Well in my research before I started this project I concluded that they were the same because I came across the same part numbers but also came across different part numbers too. It also seems too expensive for Renault to commission work on designing a new output for a more powerful engine when...

Where can I get this done around the West Midlands area and what will the cost be for all 4? It's the only thing I have to explain the lowish power. I did take the injectors from a 65BHP car but discovered that the same injectors were used across all models so I don't think (and hope not) that...

I have replaced all 4 injectors from another car, which is 65BHP version, mine is a 80BHP engine. Whilst the car runs and drives, with no warning lights, I feel that some pull power that I remember my original car had has diminished. I've been asking around and there are two approaches with...

Re-sealing it up is something that needs to be done, but if I'm not mistaken won't that just prevent the leakages, and not the creaking that occurs which I understand comes from the closing bracket?

Any ideas on this?

I want to get rid of my creaking manual sunroof once and for all. Has anyone attempted this? I'm looking to fill it with a sheet welded in and prepped and sprayed from the other side with new headlining throughout.

I gave it a good warm up and a rag around the block, issue fixed itself. I was going to do a flow back test (might still do it).

I've read a few posts of people saying that replacing the headlining can be difficult and some go as far as saying it shouldn't be attempted at al. Mine has stains on it and I was to freshen it up. Is it possible I can get a new cloth to go over the existing one without removing it? perhaps it...

I bought a donor clio to take the injectors from to put into my own clio which has the warning and tell-tale signs of an injector problem. The replacement was successful with the car starting first time (wasn't the case with previous injectors). Although the car starts there is a constant...

Just picked up the car. Can anyone advise if they're different injectors in the 65bhp vs the 80bhp. I know there's a difference in from dealers but this doesn't necessarily mean different part numbers.