Recent content by Jimmie1.4RT

Can anyone make use of this?

*BUMP* Going in the skip next week... shame.

Can't post in for sale as I'm not a member. Not paying to give something away. :rasp: Removed from a 1991 Clio 1.4 RT (phase1). Complete cylinder head with cams, tappets, rocker cover, inlet manifold, throttle body and thermostat & housing (not distributor cap). Had covered 100k miles when...

Fields can be fun!

Nice to see it again mate. :)

16V springs will go on RT shockers/dampers. But they're 35mm lower. :)

It'll look like this... ? Mark 1, phase 3 Although thats the Maxim special edition (I've never manged to spot the differences, apart from an extra badge on the tailgate :rasp:).

Run some Redex through it, might be carbon junk hanging round the plugs?

Thanks mate, Iceburg Silver. :) What skirts are those on yours? Liking them alot. Also spotted your seats. :cool:

Ooo cheers! :eek: Only joking. :rasp: You only need to undo a couple of bolts to have a look at your inlet mani. :)

Since painted the handles. Might take the valver bonnet off?

Also, if 3 bolt trottle bodies go on, you can use a larger 1.8 Laguna SPI one. It's a direct swap. :) And you can use some of the air tubing too...

Your 2 bolt TB will look like this...? While my 3 bolt one looks like this... Probally best undoing the bolts (leave the pipes attached for now) to have a look at the inlet manifold, mine looked like this.. At worst, get a phase 1 inlet manifold? Hope that helps a little mate.

Put simply, it controls how much fuel and air goes into the engine. Your throttle is connected to this and we all know what they do. :P

Thanks mate, PM sent.