Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Not sure Fraser. Like i say the night before it drove about 5 miles fine, i do go up a slight curb when i park up, been doing that for around two years, could this have an effect (longshot i know, but worth a mention)
Matt
Ah right, it flies into 5th no problem, but all the other gears, not a chance. A mate said it could be the release bearing, but as you have confirmed it wouldnt go into 5th if the clutch had gone would it? How big of a job is a new gear box?
Matt
Started the 1.4 Expression up yesterday morning, it wouldnt go into gear. started rolling down the street to see if it would go in and nothing, it does however go into 5th. Now i drove the car fine the night before, no signs of failure or anything. Would this be a clutch, gearbox fault etc? and...
Hi guys, recently having a problem with my brakes, was driving on the motorway today and the car suddenly lost power, foot to floor on a slight hill and i was dropping speed, had to pull over, tapped brake pedal and it was solid, the brakes hardly pressed in, pumped it a few times and they freed...
My SERV and Airbag light used to randomly pop on and off. But has recently stayed on, Now after checking under the seat noticed this. Are these wired correctly, i will also get them soldered properly
Thanks for the reply, that was the Pencil Coil that was goosed and has been running rough since Friday Morning, yet even after a good few miles the OBD Light on the dash didnt flash up till Friday Night, Replaced the coil today, running a bit better, still very slightly shaky when idling (idles...
Plugged the car into a cheapo ebay diagnostics thingy. and its come up with a Cylinder 4 Missfire. Now i knew i had a Faulty Pencil Coil which i have now replaced (Replaced two as they were the original grey ones) Now the engine is running better than what it was, Now tried to clear the code but...
I have noticed that my Drivers Side top mount is loose. Tightened it by hand as didnt have the correct Spanner, it tightened but didnt look like it screwed down on the bolt as no more thread shown, I have noticed again it is loose, will borrow a spanner to do it correctly, but could this be...