Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
The TDC sensor has already been replaced last year and when the car didn't start the TDC sensor was the first thing I checked, Took it out and gave it a clean. When the TDC sensor was changed I didn't change the wiring loom though.
I am experiencing some intermittent starting problems with my 182. It seems to crank over but not fire and I’ve noticed it’s more likely to start from cold then it will when it’s warm. When I’m idling the engine management light flashes but stops once I start driving. I have had my local garage...
Here Ive attached some pictures of the pipe and filter. Its feels like the pipe doesn't go in far enough. I've been trying to connect the pipe and filter outside the car so there no issue of not having enough room to push it in. I think the only thing for me to do is tighten the jubilee clip and...
I've been trying to push it in so hard that the cage is starting to warp. After I tried some vaseline it seems to want to pop back out. Clearly I'm not doing something right. I'm expecting the swaged end to push past the the rib section in the filter.
I had the serv and esp light come on and after much searching on the cliosport forums I narrowed it down to either the ABS ring/ABS sensor or the brake light switch. I went to renault and picked myself up a new switch and adjusted it according to the guide so the brakes come on as I just touch...
Thanks for your help I guess I was a bit hasty in trying to install the head unit without properly reading the instruction booklet everything working fine now. Where could a find an adapter to use the stalk controls?
When I connected just the black and white connectors the head unit didn't power up. Also when I connect my original radio without the yellow one it doesn't work either which made me think the yellow one was power. Anyone else had this issue?
Need some help from anyone that has installed an alpine head unit. I recently bought a new alpine head unit which came with its own wiring loom but it doesn't have a socket for the yellow connector. Do I need to buy a new wiring adaptor to make the head unit fit? The first image is the wiring...
One was knocked off so have bought a replacement. I read on another thread that cars with HIDs won't pass MOT without headlamp washers otherwise I would have opted to blank them.
Anyone had experience with fitting headlight washer jets on a 182? I read in another post its just a matter of removing the bumper. How difficult is the bumper to remove?
Thanks for all your input I ended up going for the p zeros at 71 a piece. Should be fitted by the end of the week I'll be happy if they perform better than the rainsport 3s. I'll try the PS3s for next time when the budget isn't so tight.