Recent content by ren182

i had the exact problem when i fitted my Alpine in my 182, what i did was remove the following :switch panel above the radio (just pulls out) and then the panel which houses the cigar lighter, this will then make it possible to remove the sloping panel below the heater controls. With these...

I recently fitted a new Alpine dva-9861ri head unit to my clio but i am abit unsure weather the hu is powering up the amplified ariel or not. I seem to find that the radio reception tends to break up intermitenly. I noticed that even though the Alpine has a standard iso connector, companys do...

I have just fitted an Alpine amp and sub in the car and i am abit confused at what the ideal low pass crossover setting on the amp should be set to. The amp is an mrv-1005 and the head unit is an dva-9861r i . Also the amp has a parametric eq switch on it where you can adjust other bits and...

I am going to be fitting an amp in my 182 and was wondering what the best way is to get the power lead from the battery through into the car, ideally without drilling holes Was wondering if there are any gromets there already which i can use thanks in advance

Thanks for that, do you know what the ideal or default setting would be for the bass and treble Hz and KhZ ajustments for general music listening?

Hi, i have just bought and fitted an 9861Ri head unit to the exsisting speakers (amps will have to come later) and have a couple of questions if anyone can advise. 1, on the setup there is this so called Bass Engine where you can alter the centre frequency and bass bandwith, do these functions...

christurbo is spot on, when i bought my 54 plate 182 new, i had the same problem with the steering wheel been out slightly. I took it back to the Reno dealer and they confirmed that the wheel can't be moved by a spline so they centralised the steering rack by locking the steering wheel staight...

I have been with Sky Broadband for the last three months after changing from Bt. I am on the connect package at £17 a month but soon the mid and max packages will soon be in my area and the price will drop to £10 whilst keeping the same speed etc. Good customer service as well

Not sure about part numbers, all i can suggest is to speak to Magnex themselves and they will sort it out for you, but like you say,,it sits spot on now with no bangs or clatters espeacially when carrying passengers. I am well happy with it now :-)

That iam not sure about, i never paid owt anyway. The way i see it is that we all paid money out for an exhaust made to fit our cars, but due to no fault of ours there were problems in fitting which Magnex have now addressed by making these mounts etc, iam sure as a good will jesture they would...

Hi All, i have managed to take some pics of the rear mounts which Magnex made at their factory, the rubber U shaped bushes are available from Magnex should they ever need replacing in the future, you can also see the 5mm spacers where the U bolt clamps on, these are also available from them so...

Hi all and a merry xmas to you, It was me who first put this post on regarding the modified rear mounts, Magnex had my car for a week to sort the sagging of the exhaust out, they made these mounts to replace the standard Reno ones and asked me to run the car for a couple of weeks to see if the...

Hi All, i thought i would pass this info on to you all regarding the Magnex cat back system for the Clio 182. For months i had problems with my exhaust sagging on the rear "standard" mountings so much so that it would rattle on the rear axle beam,and also the tailpipes not sitting central in the...

You could also check out the top off side engine mount, if the rubber is not equal distance inside the square metal surround this too can cause knocking on acceleration and de acceleration, i had this happen on mine.

As Cliokhunt says, if the auto headlamps are enabled there is no half way click on the stalk, but when you physically turn the headlamps on with the stalk you will now get a half way click