Recent content by rob_200

I have been thinking about changing my standard HU in my 200 cup to an after market one. Its been some time since I did any audio upgrades to a car, so: Will I need any kits for the steering controls (volume ones on steering wheel)? Will the new HU work with the dash display, can you can...

Cheers mate, i'll get the parents to give him a call.

Hi, Does anyone know of any good dent removal specialists in the Birmingham area? My parents are selling a car an want to take some small dents out of it before selling etc. Cheers.

My mate wants to get his wheels sprayed the same athracite as that on my 200 cup, does anyone know the Renualt colour code for the anthracite for the standard 200 cup wheels? Thank you.

Love it, stunning example!

Does anyone know of any good touch up paint for red brembos? I ask it seems of have a few small stone chips on the passenger side calipers and wanted to touch them up with some good colour matched paint. Cheers.

Cheers Tom, yeah just and went to have a look, they even have little icons lol

You know whats next lol....how do you remove the horn fuse, pull out the relevant fuse from the fuse tray @ low level? I need to make sure i get the right one as i dont want the airbag going off lol. Cheers.

I presume I will need to disconnect battery too? This bolt you mention, is it a special bolt or will any bolt do? If special, i'll order a few from you. Cheers.

I need to get access to the indicator switches and I know the steering wheel needs to come off. How do I do this, is it an easy job? Thanks.

No doesnt seem to happen when reving high. Yeah tried adjusting the steering column as well. Its probably something simple, but just wanted to ask if anyone else had it and resolved it.

Ok I know its French and I can take most rattles etc, but this one is getting annoying. There seems to be a vibrating/buzzing noise around steering column when going over slightly rougher tarmac, only started recently. Sound like something is loose and then vibrates when the shock from...

Cheers people for all your replies etc, I think i'll take a look over at 197 at that guide.

Only going on what I have read lol, is that the wrong way to go?

I dont have a grinder lol, can it be done manually by sanding? Do you mean chamfering the edges etc? I'll be using lots of copper slip as well me thinks! Whats the best method to knock the 2 pins out? Use a hammer and something to knock the heads of the pins I presume?