ClioSport.net
This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Struggler's latest activity
-
Struggler replied to the thread Braided lines for the centre section..It should be just a case of specing the length and end form and getting them to mock them up. Are you planning on running them along the... -
Just read from beginning to end, brilliant thread! Nothing worse than having to go backwards on a project but as previously said you've...
-
Struggler replied to the thread Ignition not turning off.Well, if anyone else reading this has some wiring diagrams for the ph1 showing where the switch lives from the ignition barrel go that...
-
Struggler replied to the thread Ignition not turning off.Is there a relay bank in the car that houses a main ignition relay do you know? Sounds like a good start. Yeh already got the hazard...
-
Struggler replied to the thread Ignition not turning off.I'm also running a gen90, not sure there is cross over with that... Is there a main ignition relay somewhere I can investigate? A...
-
Struggler posted the thread Ignition not turning off in Interior, ICE, Security, Lighting & Electrical.Bit of a weird one! But went to run up my track car this evening to find the battery completely dead. Not a sausage. My nephew had been...
-
Struggler replied to the thread Fan Wiring.No worries, I'm pretty sure I've sorted it. I wasn't sure even which one the fan plug was, since I dumped the fan a while ago during the...
-
So my ph1 headlights are in pretty poor condition including some internal adjustment mechanisms broken. Most of the genuine ones you...
-
Struggler replied to the thread Fan Wiring.Sorry, just realised that pin A5 on relay 234 goes to pin 2 on the resistor so doesnt actually go through the resistor. My comment...
-
Struggler replied to the thread Fan Wiring.That is excellent @Brigsy Thank you! Studying this and my ph1 wiring I believe it looks like this on the ph1: I am not sure in your...
-
-
Struggler replied to the thread Fan Wiring.Awesome! I am also trying to adapt to a comex fan. Would I be right in thinking the plug with two wires going to a single terminal...
-
-
Struggler replied to the thread Replacing Clio 172 ph1 center radio frame.Yikes! That's a big hole! Bottom dash off unfortunately to access behind it. I'm pretty sure there's stuff in the way of you try and...
-
Struggler replied to the thread Fan Wiring.Hey, any input is appreciated! Knowing it's a resistor definitely helps because my theory does make some sense assuming it's just a dumb...
-
Struggler replied to the thread Fan Wiring.Unless it sends power via the resistor for a low speed mode and direct to the motor for high speed? 🤔. I think the low speed mode was...
-
Struggler replied to the thread Fan Wiring.Hmm, could be! But what would it need a resistor for?
