ClioSport.net

Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Recent content by tonaz

  1. tonaz

    182 won't run right after putting standard exhaust and inlets back on mapped car

    i have started it and left it and started it and left it a good few times. does it need to be driven? just it's not on the road anymore
  2. tonaz

    182 won't run right after putting standard exhaust and inlets back on mapped car

    i wouldn't have thought the exhaust could be blowing that much. the inlets have brand new ptfe gaskets on. don't think they can be blowing either. will try to double check everything tomorrow. could i have done summit to it by sarting it on the custom map but with standard exhaust and inlets on...
  3. tonaz

    182 won't run right after putting standard exhaust and inlets back on mapped car

    hi all. i am busy putting my 182 back to standard. after having the standard exhaust and upper and lower inlet manifolds back on the car is running very rich and cuts out when not on throttle. the car had a custom rs tuner map on it. i put the standard map back on and it's still running the...
  4. tonaz

    putting a fully stripped 1*2 back together... struggling with rear seat belts

    cheers for that, yeah i have put the plastic bit back on the roof i take it this needs to be bolted on there? i have the bar to put back on too. where does the bar go? thanks again, tony.
  5. tonaz

    putting a fully stripped 1*2 back together... struggling with rear seat belts

    cheers, i have looked everywhere and can't see anywhere that the part in the pic on the left can go? there are no holes that the sticky out bits can go into under the seat cushion (or rather i can't find them!). as for the pic on the right i'm sure it goes at the top of the passenger side where...
  6. tonaz

    putting a fully stripped 1*2 back together... struggling with rear seat belts

    hi all. i am currently trying to put my stipped 182 back to standard and am struggling with getting the seat belts back in right (a result of paying no attention when taking everything out). does anyone have a diagram that shows what goes where or anything? i am part of the way there but can't...
  7. tonaz

    north east auto electrician needed gateshead/county durham way

    hiya. i have a 52 reg megane that won't start. it's coming up 'elecrtronic fault'. my girlfriend needs to drive to london in the car on friday night and i need to get someone out to have a look at it. have tried fuses etc, battery is fine. can anyone help or does anyone know anyone...
  8. tonaz

    electrical fault on 52 reg megane

    the steering lock doesn't work mate so can't really tell. was fine until yesterday morning but started when i disconnected. then wouldn't start this morning. was fine before. cheers, tony.
  9. tonaz

    electrical fault on 52 reg megane

    hi everyone. i have a 52 reg. megane and it won't start. when you put the key card in and push the button either nothing happens or it comes up with 'electrical fault' on the dash. i have tried disconnecting the battery for a bit and it's still the same. all the other electrics and...
  10. tonaz

    where to post a thread on an electrical fault on a megane

    as above please... i.e. which section on this site or which other forums to try? cheers, tony.
  11. tonaz

    Silver 182 Machine polished

    have you checked the for sale section on here there should be some for sale. would also maybe check the k-tec web site?!
  12. tonaz

    Silver 182 Machine polished

    the rear one is just the standard cup spoiler it's been on since new
  13. tonaz

    Silver 182 Machine polished

    they were. they've been replaced now ;)
Top