Search results

I'm not wheel spinning it lol well not anymore

Well fitted the new washer and clip all feels good so fingers crossed it last. There was no welding done lol

Guess the didn't consider it dangerous enough to recall

Total pain in the back side. Pulled out a junction then it just revved like mad with the speedo shooting up.

3 times its been. First time the washer totally snapped the other 2 I was turning think the other 2 times was because the washer wasn't in ill try it without welding it so that I can take it to a garage and get it replaced with something more reliable

If I knew the hassle that came with this car I'd avoid it

It's a great engine in it lol

Guessing its a tight fit then

Yes but does it matter what one goes in first

What way does the washer and clip go back in

Hopefully wont have the car long enough x

To stop it from popping out again

The bit that the ns driveshaft goes into

After a lot of hassle with the circlip iv decided to replace it and weld it in place. What my mate wants to know is what material is he welding with ie casing circlip and the slit where it goes into. Thanks guys

Ok so I push it towards the rear of the car thanks

Do I push the bar away from me or pull it

Anyone

Best way to release the tension to get it over the pulleys thanks

Ill give it a go tomorrow need to get that socket tomorrow

Yea but can't get a lot of access

How would I get the engine down lower so I can get into it without the sump hitting

What is the bolts holding in the housing

I took the top cambelt cover but when I lowered it but sump hits subframe

Yea but when I drop the engine down I can't really get great access also what is the bolts holding it in.

Water pump has totally gone how easy is it to fit a new one and what does it entail

Yip 5 mins away

Anyone

Right I'm looking for the wee bit that joins the selector to the linkage. It's held on by a 13mm screw looking for the bush and the wee tube. Gear stick has a lot of play and I think this is the cause of it

This hasn't worked I think both levers have gone