Search results

Tutuur try looking through these for ECU pin layout, I'm on my phone so would take an age.

Just looked you have a Dci so I'm guessing the ECU pins will be different.

Underneath the N/S scuttle panel, also you'll have to remove the front wiper mechanism. Then a 10mm bolt removes a block to which all your wires will need to be added. 5 wires will need to be added. B8-B9-B10-B11 ( cruise wires ) G5 ( Clutch sensor ) Can get proper diagrams they're on my PC.

I had to make a wiring loom and connect from the bulkhead to the ecu. I bought some connectors and went to a scrappy and grabbed an ecu plug and used connectors from that.

Did you ever find the spec for the bolt for the ABS sensor my guess is M6 x 30mm?

AlexW

I've done dressle, seen a select few with verso before Christmas. So unsure of a deadline, my understanding it was a product per month and the review has to be done within that month to stay on board.

Yes, mine was wired inside the car but not in the engine bay. So I had to make a loom to add it in, now hoping reprogramming will make it work.

As it stands now, cruise won't work until reprogramming the ECU and digital dash for aesthetics? Well I hope so, as when I saw the cruise loom in the cabin I though it'd be an easy addition.

Something is wrong my end then MicKPM. I 'hope' all wiring is in place. I had to wire from bulk head to ECU. I have belled wiring from ecu pins to the respective wires inside the cabin, yet nothing happens when I activate cruise and operate the + button. I also have a N3 UCH. Its a PH3 1.2...

325

They can be hard to twist after reaching round the back ;-)

I've changed the bulbs without taking the heater panel out. Just a bit fiddly.

Oh awesome I guess they'll be that little bit harder to find.

I searched for similar to yourself. I found that they're on 53plate onwards. Mostly are dynamique's with the optional 'cool pack' that comes with electric sunroof. Plus with a 53 onwards it'll be a PH3 so much better :-) good luck finding one.

I'd make sure the front springs are correctly seated, as they only fit 1 way. If they are, get some heffa to bed them in by bouncing on the front end.

549

Are these the drift tyre that Japspeed sponsor, or am I trippin'?

287

You need to remove the metal cage. There are metal tabs that will needs to be bent back, these help hold the cage in.

Can't wait to try Verso, after Satin, Spirit and Dressle are something to go by. Quality not quantity.

Someone just quoted the username with and without the full stop. Post #8 & Post #10

Take the panel below the heater off yes, nothing else.

It will be the bulb behind the heater that'll have gone they're are twistlick T5 bulbs. You can access the back if the unit via the panel underneath and above cup holder. The panel needs to be pulled out towards you

The OP followed the instructions on post 4 and got CC to work but no speed limiter. SET was displayed on the center LCD.

Hit it! It may be a bulb that's gone.

Either locked out as above. You can use the numbers also as stated in the radio manual. Also could there be a possibility is that you have a tuner instead of an update stereo or vice versa. I have a fully functional update list stereo one with a code a know that works.

347

How are you entering the code and at the end what are you pressing to 'enter' it. You maybe pressing a different button, or pierre is pulling a good joke on you.

Welcome. This thread should have some info you're after, don't be too shy to search :) http://www.cliosport.net/forum/showthread.php?t=726473