Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Hi, I've swapped the seat rails over on my drivers seat and attached the cable for making it tilt and slide. This wasn't connected when I took the seat out to sort the sliding mechanism. When I pull the handle it tilts fine but as it folds forward the cable to the runner pops out of the slot...
Hi, I've stripped the Cat off my 182 as the previous MOT said it had a leak and it was covered in exhaust paste. Anyway after an absolute night mare getting it off, I think the leak was down to 75% of the gasket missing but I think the Cat is goosed anyway. Exhaust paste on the brick inside...
Follow up question. For the pipe that connects to the side of the condenser. I have 2 types of seal the same diameter but one type is double thickness. The one that was on when I took the old one off was none oem and single thickness but with signs of a leak. These are the ones which come in the...
Hi, is there a page which lists all of the different fasteners. I've had a look but couldn't see one. Does anyone have a link for the following or know what type they are?
1) fasters for the engine heatshield
2) bonnet liner clips
Thanks in advance
Hi. Sorry if these are dumb questions but here I go.
1) On the aircon dryer. Which pipe goes to the 'IN'. is it the pipe connected to the condenser or the pipe which loops back around the front of the car. cant see any markings on the original dryer.
2) when you refit them all. do you fit the...
It’s a shame about 3D printing but as above. If you had the model it would take about a week to print, cost about £40 in material and that’s if it didn’t warp or come off the print bed mid print. It would have to be thicker as the printers don’t like the to do big areas thin and after that you’d...
Hi. Does anyone know how to remove the cigarette lighter from the surround please. I can get the main section to pop out but then gets caught on the yellow part. How do you separate the two parts to get it out of the hole?
Thanks.
Its the front part of the instrument cluster itself isn't it? Doubt you can buy the clear part separately. Prob have to buy a good condition cluster and swap the part over from that to yours. About £20 on ebay
Ok so tried a new resistor pack and same thing so got a spare now. Still no blowers. Anyone know which the blower fuse is please. Not very clear on the fuse panel cover. Control panel all seems to work. (Well it lights up and changes when I select a/c, blower speed etc).