Search results

😂 He seems to have asked a question and then answered it himself, by quoting himself 😂

Upwards of £500 seeing as it's off a reliable source.

You won't feel the benefit of uprated pads in the rear on the road mate.

Yeah but you aren't giving them death on track 😂 Standard brembo are fine for the road.

Yeah definitely easier.

You're a dodgy c**t you 😂 I like it 😅

How many days did that take 😂 The Milwaukee is the quickest out of all the ones I've seen in a review. I think they say after 10 minutes of continuous use to let it sit for 10 minutes before doing any more.

I've looked at them but buggered if I'm paying £90 to inflate my tyres 😂 And they overheat after about 2 tyres 🙄

Yeah my dad's Ryobi brushless grinder has one of those. Easy enough to use.

Can you not just get a new ecu?

Definitely a lot easier than trying to do it on the road with people dawdling everything.

Yeah you can do that with them. I do the same with my PBS.

From further reading the initial posts, it sounds like the bedding in procedure wasn't done correctly at all. 5 stops from 40 to 10 is no where near enough. Need about 40 stops from 100 to 30 on these.

They'll take over 800°c Absolutely no one is getting them that hot, unless the brakes are seized on for a full session on track.

The whole bit comes off, plastic bit and the metal tube. Had to heat mine up and stick it in a vice with some grips on it to get mine out.

Yeah fine. Identical to the one I got from Autobrite Direct.

You remove the fitting from yours and screw in that silver adaptor you see in the pic, with a bit of PTFE tape.

My old karcher attachments got harder to push in the older they got. I think they must have an o ring inside that gets a bit hard over time. Give the end a spray in some silicone lubricant.

Yeah the yellow Kirkland ones are ok for most jobs. I'd use a better quality one on premium paintwork mind 😅

Tbf if you're not arsed about trimming them down, I'd imagine they'd be alright.

Similar thing when we tried to fit a set to my mates car. They bend that far towards the brakes that it hits the brake lines/caliper on full lock. Would have needed a fair bit trimming off. Better off making your own.

Yeah looks to have just sheared off where it goes into the rear diff.

They must be reading CS. Mic volume a lot better now 👌🏻

Guy on the mixer needs to move the slider down on the mic volume 😂

On now.

They are in their EDT now (Eastern Daylight Time) which is like us going to GMT+1 So they're always 5 hours behind I think.

His video on the Cleetus2 channel earlier said 4pm with main stuff kicking off at 5pm. So that's 9 and 10pm here.

Does look a bloody good used caliper that!

A race with a load of YouTubers in Ford Crown vics. You'll have to wait for it to appear on YouTube in a few weeks now.