Search results

CarPro Dlux, can use it as a trim coating as well.

Saw that one. Shop Tool Reviews.

Still can't get over how quick this is :oops:

More than likely, the TL4 gearbox is renowned for it unfortunately.

You can talk 😂

That's a non Fuel version kit, but more than good enough for DIY.

70Nm mate They give a bit of a kick when tightening up at full speed and it cuts out when tight.

What's wheel cleaner 😂 Lucky if mine gets a wash 4 times a year haha, always doing every bugger elses.

This and I give the studs a go over with ACF-50 once in a while and they look as good as new.

I thought you were going to kill yourself in the first two laps you mad fucker 😂 You were properly over-driving it at the start but then settled down and kept a steady pace.

Definitely Halfords over Sealey and Nielsen.

Tried a key battery?

Push the fitting on until it clicks and then give it a good pull. You shouldn't be able to pull the connector off at all unless the tabs are pushed in.

Not used Perl. I think @Sunglasses_Ron has. Wouldn't imagine it'd be more than a couple of months.

Any of the fabric sealants are good. I've used the Gtechniq and Gyeon and there's nothing in it between the two, both easy to use. You can't really mess up a trim coating mate. Go for CarPro Dlux and you can use it on trim and wheels. It's literally wipe it on, wait a minute and then wipe off.

Need a multimeter to check the voltage really. It should be ok if it was brand new, but it's worth a check.

Oh that's definitely not right then.

😂 The old slider trick gets them every time.

Looks about right from what I can make out. Maybe a tad closer than normal.

Definitely got enough battery voltage?

EX04/06 is the DA version of Perfect Finish. Both near identical 👍🏻

This.

Tbh it says circuit on the fault which would indicate it's a wiring or sensor problem. I'm sure it says something else when it's an abs ring issue 🤔

Decent drying towel 😅

The dust isn't too bad to wash off though. Not like Carbone Lorraine pads!

Answer is yes

Aye yeah! Be interesting to see if the head on that is the same size as my 3/8 extended.

I was under the impression that the extended ratchets had the same size head on the end, just the anvil was different.

I've seen something like that yeah. Mine is the 3/8.

Yeah boot sensor I'd say too. Check the wiring inside the solenoid, one of mine had broken off the solder, I'm guessing from being repeatedly slammed over the years.