Search results

Problem is your calipers have been milled..so won't work with the 300mm brackets

Thats frustrating. I was told 280 would work without spacers using cup turinis. The whole reason I went for them in the first place..

It doesn't look like you've installed them incorrectly. I really hope spacers aren't required as I bought them on the premise that they would fit without spacers

@chris powell might be able to assist?

Have they used an incorrect hub perhaps? If you know which brackets they are it might help..

Yeah I think there's something wrong in the install. 280 should clear the cup turinis without a spacer.

Strange. There's lots of info about the brembos fitting and I've got a set too. Have you had some machining done to the calipers?

Which brackets you using mate? Surely if it's not touching the wheel then it's fine? Even if it is 2mm clearance

Doesn't look too bad. No structural damage just body work which is always better than a head on or rear hit. Doubt they'll write it off

Think ups delivered mine

That's a shame mate. Looks a good base track car for someone

How the heck did he go from 5th to 1st?! Have you been pumping his missus or something? It's not exactly something you do by mistake..

I tend to just replace air filters when I'm nearby a euro car parts. They cost peanuts from there so always keep a fresh one in there. How much are the k and n ones out of interest?

Yeah new one won't hurt

Yeo they would have mate! Only issue would be running 15s..

Amazing price

They look brilliant mate. How much did you pay for the pair?

Yeah it's not really needed mate. There are two yes. One at the right hand side of the airbox and one at the front. Apparently not really jeeded

It connects from the air of to just below the headlight. Bloody bugger to get back in though

@Craigarch1994 any ideas?

So noticed a slight ticking from the engine after the belts have been done. I've booked it back in for Wednesday for them to have a look at it and see what's what. It's a reputable garage that's carried out the work (SWR in Stirling). I've checked a few threads and folk are pointing towards the...

Thanks a lot mate

Like he's on casters!

Yeah no worries mate. Just wanted to confirm before the engineer starts doing something different! Where did you guys get the pin kit for the brembos?

Cheers Dave

Only issue with that Marc is if I end up fitting 15s it's a no go!

You should be ok mate. Mine were packaged properly and are 100% new.

I've bought brackets to fit the 280mm discs..is there a difference?

Ok, so which part of the caliper is to be machined? The part closest to the front or the back?

So I have almost all the parts for my Brembo conversion; Clio 200 brembos 280mm discs Hoses Pads Brackets Now my understanding is that 5mm needs machining off the calliper mounting point(where it attaches to the bracket). Is this correct? I spoke with a motor engineer today about getting the...