Search results

Yes you can!!!!

Anyone managed to fit air suspension to a lio 16v yet? how is it???

I want to get a chrome/polished rocker cover and also inlet manifold plus some other chrome bits for my clio 16v engine? anyone done this? How much you pay???

you can cure it for good. Buy a tube of stikaflex and then remove the roof and clean up the edge. run a thin bead of stikaflex around the roof where the seal was and then replace the roof and secure the bolts again. once this has dried no more water ever!! i've cured mine now for 2 years

Sounds like the gearlinkage is not correctly adjusted. Remove this and then using the knurled bit on the gearbox select all of the gears! If this is easy to do then its the linkage. if its not sounds like the selector fork in the gearbox!

your grounds not connected properly and the power source is too close to the screen

have you packed the inside of the box with wadding? I would do this as it restricts the air to the subs and then tightens the bass up. you should also change the frequency on the x over to below 80mhz and then start with the headunit on 0 for bass. then turn gain to minimium. you can then turn...

nice box, i'd like to find out more as wanna do my own fibreglass install.

Has anyone re located the fuel filler on the clio? I have disconnected the fuel nozzel from the bottome for the fuel tank and the wings. There are three tubes. One large that goes to the reserve tank and then two small ones that seem to go to a rail running down the side of the tank. What...

How much would it cost to get a set of throttle bodies for the clio 16v? if you have chip cams and these what sort of power should you expect??

FK suspension is not that good when compared to KW and alike!! I would go with another company that allows you height and damping and rebound settings

I want to take out my fuel cap and weld it over and relocate it to behind the bootlid. Does anyoone know how you remove all of the pipework under the drivers side rear wing and also if there is another blanked hole in the tank that you can connect a new filler pipe to?? Has anyone already...

there is no way thats running 220 bhp and they are NOT 19" rims.

all you need to do is buy the clio16v engine and gearbox and then the engine wiring loom. with engine mounts about £450, then just drop the whole lot in!! easy only take about 4 hours!

I have 19" rims on my clio and lowered 80mm at back and I have not moved the fuel filling pipes, and they dont rub

I can get hold of carbon roofs for all clio models. the one on my mates valver looks awesome and is a one off

yes but a good kit would probably be about £700 and you could fit it yourself once its been properly built.

I am in talks with a company at the moment about using my car whilst its being rebuilt to develop a bolt on lambo door kit for the clio 16v. This should solve all the problems.

it has never been done sucessfully on a clio 16v without wing rubbing and doors not closing properly, you would need a pro to design and fit the kit in order not to have serious problems.

bump

well I can see the differences between the loom, i seem to have a set of wires missing that are controlling my fuel pump! Think it might be an idea to get a 93 wiring loom that matches the one i originally had??

how do you know you have the right one??

oh right cos i have a k plate and it was taken from a j i think?? do you have any looms? whats it gonna cost me?

has no immobiliser? and which one is the fuel pump relay?

I have just installed a new wiring loom in the engine section of my car which i bought off the forum. I connected it to every ancillery on the engine, one end to the ecu and the other to the relay box besides the battery. when i turn the key on all of the dash lights come on and one of the...

no you have to move the clio stereo location to where the top two airvents are. I made a special enclosure for mine and it looks and works sweet.

its MOT legal to have the doors pop off the remote. I have no handels inside or out and can only open the doors off buttons in the car or the remote. Plus I have had the car MOtd twice with no problems

DIY shop sell it by metre

Anyone know where you might get one of these from and possibly whats the cost?

no the 16v one is slightly wider