Search results

want to go bigger than 19"

would it be possible to fit a standard clio MK1 rear beam to a clio 16v and then use spacers to bring the wheels out enough to get them properly in the arches?? I am looking at how big a wheel you could fit in the arch before if fails the outer casing of the torsion bar?? Anyone really know...

Im looking into putting the valver onto air bag suspension then it will be low!!!!

just need a different manifold to be made to join the two exhaust systems and then your rocking

so what type of modifications will you need? What if I have a,clio 16v with 4 pot racing brakes, alloy wheels and racing suspension and anti roll bar set up? Would this be cheaper?? do you actually need to change the subframe??

How difficult would this be? what would you need to do the conversion?? a complete doner car?

how much would that cost?

What is exactly involved in fitting a gt turbo lump in a clio 16v?? has anyone got a very quick one??

i have the 330mm setup on my valver. send me your email address and ill post them up

Does anyone know how much an engine rebuild would cost?

Does anyone know what the correct timing would be on a valver running piper cams and vernier pulleys?

Has anyone tried to fit a honda civic type R spoiler on a clio tailgate? Any pics

I would like to know the part number for the clio16v exhaust heat shield??

clio 16v discs, pads and calipers and thats it. will bolt straight on. What size rims do you have as the standard steelies will not fit after the conversion.

Does anyone have some fitting instructions on how to install a FSE power boost valve on the clio 16v? Could you please post up with any pics? How do you set the device up??

I have managed to get hold of a Clifford Concept 300 alarm which was taken out of a written off clio 16v. The alarm is complete but I would like to have it installed into my car. Does anyone know about the wiring of these products or can recommend a car sparkie to fit it? im in the herts area...

any pics? and where did you source the switches from?? I have been looking for ages??

i know its not actual chrome but it is the chrome effect.

cant be done

the plastic paints smudge and fade and if you lacqueur over them they just go matt finish? Its a very strange paint almost as though they dont actually set? Would be keen to get some more info on the plating

Can this be done and is it expensive??

Im looking to source some chrome or stainless steel switches? for hazard lights, electric windows, fog lights, rear heated screen etc to replace the ones on my clio 16v? make them more custom? Any ideas?

Try NV autostyling they are superb they just did my clio and its mint!!

My clio is on the front cover of Revs this month!! After a years hard work i have finally achieved front cover! Hope you like it! except the colour in many cases!!! Thanks to lots of you for advice and support along the way!!

i had my clio 16v dash done in leather and alcantara. it looks awesome!!

I had this problem with my last clio and its just a fault of the design! it leaks around the sunroof seal and the arial! I cured mine for good! what you need to do is take the sunroof surround out and clean both surfaces with white spirit. then buy a tube of stikaflex or tiger seal. put a...

yes PM me your email address and ill send you some

I have done it in my valver. took out the heater vents in the centre and built a custom dash point. Looks PHAT!

it may have done when it was transported?? two idiots had unloaded it?

not on mine they are jammed