Search results

That's because you're not on your back with the car on axle stands and swearing at what room you have 😂

Are the front carpets damp at all? The rough running/spluttering could be old fuel.

Have you checked the tie rod for straightness?

The Simpson isn't a once size fits all too, so you need the one for your chest size. Something to check if going second hand.

That's just the cost of having it re-certified when out of date.

Simpson Hybrid, they're like £700+

£600 is a good deal.

Renault did it with the R26.R 😅

Almost always 20 degree for bucket seats.

Yeah it's hard to overcome the natural reaction, took me years. Looks like you did try to blip the throttle but it was past that point then. One of the reasons i hate wet track days 😂

Do you reckon it was the rear toe out that caused it or the zero throttle on entry? Everytime i've been off in the wet it's been down to no/not enough throttle. It looked like you could have potentially saved that by getting back on the power, but at least it's not too much damage.

Weird, could be the weight. Definitely better than OEM on the Megane.

If it's for road and occasional track, try Performance Friction Z Rated pads. They last ages, no noise, low dust and ideal for the ring.

Sounds like it will need recoding with a proper scan tool to input the ID's

Not sure if it works on the Clio, but on the Megane you scroll to the tyre pressure reading and then press and hold the up button for a few seconds and it'll rescan and pick up each wheel as you drive. That may not work for you though if it isn't picking the sensors up to begin with.

Hi Tony mate I'm not admin, so I can't check 😅 @Nik should be able to

If you go to your profile and go down to Club Memberships, you should see a cancel button. That should take you to Paypal for you to cancel the automatic renewal.

Only worth doing if you start killing CV's really.

What grease did you put in? Redline CV2 is good high temp stuff but a bit expensive.

Yeah much better. They hold up better to the heat compared to rubber ones. Only use rubber/neoprene ones for inner boots on tripode joints tbh.

Looks like a decent thermoplastic one too, like oem.

As long as the spring is seated securely, you won't need to touch it. You don't really need to preload linear rate springs.

VF1CBN0xxxxxxxxx That's the vin showing for me.

What's the reg?

You'll want a hard drive which is purpose made for surveillance and not just a regular HDD i believe. Something like a WD Purple or Seagate Skyhawk.

Where abouts are you? Maybe someone local could activate the pump for you using diagnostics.

Good old Deox-C. Not seen Hydrate-80 go that black before, looks a really good finish that.

Should be achievable mate, you know what you're doing. Not a complete amateur 😂

Yeah will do the job.

5000 and 7000 will get it like glass 😂 Could even get some paint mixed up and dab it in to the scratch. Solvent based paint is better, mix it 50:50 with clear coat. When it's dry, level it off with a denibber or sand it.