Search results

try a coolant temp sensor

OP means the length of the aux belt on a 172 cup set up with PAS pump removed it'll be something like a 6pk850 but don't hold me to that

Sport lines are a bit cheaper from Germany http://www.ebay.co.uk/ulk/itm/321927308074

A copy of pure motorsport kit by the look http://www.ebay.co.uk/itm/Clio-172-182-aircon-and-pas-delete-kit-/151939365261?hash=item23604ab98d:g:T~0AAOSwa-dWi3K1

Dodgy throttle body or drawing air in the inlet gasket would be my first guess

low 6's in the hillclimb car 4's with a ktec remap minimum!

I leave moisture traps in my cars that don't get much use, http://www.ebay.co.uk/itm/201472903643?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT I also start them up once a fortnight let them get up to temp and drive them around the block while left foot braking and easing the...

top work, the maxogen looks well like that

The port work is factory, Regards knocking, is the dephaser shagged!

Undo the bleed screw on the stat housing, if that's ok change stat,

I had a sum up at work a few years back how much an Iveco daily van would cost from the parts bin as the prices were ridiculous, a £22k van worked out at nearly £110k, plus fitting

That was over near Malton Dan, no, only going really steady but BMW in their wisdom have put the intake in the front grill,

Dropped a right bollok, after 2 hours of waiting for BMW assist I got bored so with nothing more than BMWs supplied flat blade screwdriver and a top notch swearing phrasebook I got it running after removing the air filter, air box & intercooler pipework thank fcuk for that! all seems fine but...

Yeah mine is only noticeable in first gear when turning sharply and even then not any where like as bad as the older grippers I've heard

I'll give you that, it is pretty near perfection yours, I've got the 8oz tapping hammer if you prefer, i'm good with that

as yoda said There is no try, do or do not! ( I use that on apprentices ) I'll finish the cup for you in a day, cable ties gaffe tape and a 4lb hammer, no guarantee on the quality of the finish mind.

get on with your cup and stop p!ssing about

Just noticed the PMS kit in that picture has the water pump rotating backwards Edit: no it's not just me being Dumb!

go for the cup set up if you're going epas, as the belt run will be a lot shorter. cup set up with p/s delete: PMS with P/S delete

cup set up is the way to go

if it was a Luk clutch kit on the invoice that may well be the problem, There has been issues with them after a few thousand miles.

I'll be there but probably on the Friday as it's quieter

HOLY f**k. I couldn't drive that without a balaclava on

ack sore it toff

well it takes all sorts but here you go mate

water pump will turn backwards like that and may walk the belt off the pulley as it doesn't have the groves for the ribs on the belt to run in, @NorthloopCup what do you reckon?

We're turning into Team America, Just watch for Dave Cameron doing the International distress signal.

When I saw 201hp I nearly fell of my chair I laughed that hard. The guy from Turkmenistan is going to tell anyone from here who try's to order one to "go fcuk themselves" and I can't say I blame him.

Those PS3's will have been through a very good heat cycle and have a hard layer, use them on the road for a week or two just to scrub them in again and take that hard layer off.

coolant temp sensor?