Search results

I can do a custom map for you at £250 including an engine health check. I did another one this week, his thread was in this section somewhere.

Or you can bend the tools.

If the inlet cam is too far advanced, it'll idle perfectly, then at 1500 start sounding like an old fiesta.

Tbh with how strong it feels I wouldn't be surprised if with an RS2 fitted, it'd crack the 200 mark aswell.

Or, there is no fault and it's just the exhaust making it sound like there is.

What are the figures?

I'm with Fred on this. I think the timings out.

Renault sell them I think.

That's why the bearing has failed.

Well you've answered your own question. Oil pressure issue, probably spun bearing caused by low pressure. Tbh any decent tech would've known that a noise caused by low oil pressure wouldn't have sounded like a dephaser. Although if the garage diagnosed it as a dephaser and it didn't fix it...

Just buy a new one.

It should jump from 0.2v to 0.7 Ish.

The cable all the way to the sensor is ok? Is the sensor damaged by the driveshaft?

Lambda sensor. Precat.

You'll be lucky if you can unbolt the stub axle without holding the bolts from the disc side. Yes I think you'll have stripped the threads on the stub axle.

Cutting disc into it both sides and chisel it off. Replace the driveshaft too. And the wheel bearing that's knackered.

I charge £115 flat rate, this includes setting it correctly if it is incorrect/

Tbh if your dead set on cleaning, spend £10 on some carb cleaner, take the inlet manifold off and give it a good blast out. £70 saving.

I charge £350 to do a box swap inc new valeo clutch

Pointless.