Search results

Depends on tyres, dampers, springs, tyre pressure and 50 odd other things but for reference with cup dampers, cooksports and a rear anti roll bar and good road tyres Front -2.5 camber 15 minutes toe out castor isn't adjustable without fancy top mounts, but as much as possible, 4 degrees ish...

try barring it across 15mm dan, just make sure the box has room to clear the chassis when moving under load. (for reference 15mm = 1 penis length):up:

is the gearbox hard up against the chassis rail?

one of the 4 base mounting holes need a little elongating but other than that they're plug and play £45 seems the going rate

any mk1 any engine (1996-2003) scenic will fit, scenics have a taller turret/tower if you just extend a mk2 clio lever you will also end up with a longer lever movement to change gear fitting a scenic one changes the fulcrum point to higher in the tower so you end up with the same standard shift...

exactly what I was thinking dan

who made the shafts

Some of the wife's inheritance will be there

did the vibration not show itself on the dyno ?

@dann2707 ???????

I'm starving now I've seen that Indian, But ffs chips should definitely be banned or at least jizzed on by the kitchen staff

Great looking car Benjamin, those Sparco terra's look good too

It ended up pretty much like yours

I fitted a campus grill to the hillclimb car last year and needed to do a little trimming to make if fit perfectly, they are close but not identical to each other size wise.

Made by norbar, good quality torque wrenches for the money. I Torque wheel bolts to 85 ft/lb

Yeah better off buying a solid flywheel, then the new keeper won't have to worry about it:smile:

another vote for pre cat lambda here

genuine cup splitter buddy

Great photo matey :up:

Pd engined cars are soooo Bradford............:car: :policecar::policecar: :policecar: :policecar::policecar::policecar:

Use a string line to get the wheel alignment near enough to drive it about Dan:up:

Could be down to a less grippy surface

Have you owned all the cars ever built yet Jim? Can't be that far off now.

Ballast resistor faulty buddy http://m.ebay.co.uk/itm/300870871475?_mwBanner=1

Eibach Sportlines PH1 OZ F!'s

04 reg silver 182 heading into crossgates from colton

only air bag, abs, traction control, elec power steering and tyre pressure monitoring systems lights are testable

Does it obviously have an airbag missing, (ie, aftermarket steering wheel) if so it will most likely fail, if not obviously missing it will pass fine

Mine runs 400mbar with 438 cams, so I would say yours is acceptable if a standard motor