Search results

can only recomend TBR, did a fantastic job of my dash

lego heads 182

63mm is 2.5" yea?

yer if he stocks them , then pay monday you will recive on the tuesday. :D

diz maybe cos of da trackin, or da wheel balnzing

contact yoz, he can send them through www.sentitnow.com for £10.99 next day delivery. upto 30kgs

cant re use rear bearings, and those ebay disks wont ahve the abs rings fiited, so you would have to swap them over on a bench. rear bearings about £20 a side for drivemaster units, thewn a garage would hafve to press them into the new disk use normal renault pads and disks for the rear...

mm mine was all the way through. yes you could drill out the hole

most, but you will also need to buy psh1 inlet plenham, t/b , TPS, throttle cable, cable pedal, psh1 gearbox as the psh2 speedo runs off the rear abs sensor which is managed through the UCH which is not part of the psh1 loom. so you need the psh1 gearbox to run the manual speedo drive imput

yup

what about some evolutions like mine ;)

even cheaper :S http://cgi.ebay.com/ebaymotors/HID-Xenon-kit-9008-9005-HB3-H11-3000K-5000K-6000K-8000K_W0QQcmdZViewItemQQ_trksidZp1638Q2em122QQcategoryZ36476QQihZ008QQitemZ180207370357QQrdZ1QQsspagenameZWD2V

or jsut cheap s**t? http://cgi.ebay.co.uk/XENON-H1-H3-H7-H8-HB2-HB3-HB4-HB5-HID-CONVERSION-KIT_W0QQitemZ180208124517QQihZ008QQcategoryZ9895QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

yea, the headlight clusters you have wont spred the light correctly. they need to be optic lenses, like on the psh1 172 etc,

my BMW passed with a HID kit

you wont have to drill as the whole is already there. the OMP is smaller, so will fit through, then you have to bolt it either side, its jsut not ideal

f**k me! look at the welds on the exhaust LOLOLOLOLOL

http://www.motorgeek.com/phpBB2/viewtopic.php?t=9648&start=0 wish i could machine like that :(

lol

erm you would have to take the bumper off if you drive 230 miles to warrington , il fit it foc LOL

any recomendations for where to buy the pins? dont want cheapo ones

im doing it on my build

mine (as its a psh1) has that hole already inplace, iirc they used the psh1 shell untill 04

sorry my bad. LOL as said, il take a rear dude

dave im not sure you can fit the rear one

did you get that discoutn timmo?

you are pulling anti clockwise?

craker bar?

it wont fit, i have two of them (and the propper cup racer) you can fit the omp one using the propper nuts, washers, but its hard work and i dont think yours had them on

whats this costco value thing for all 4 tyres?