Search results

Managed to get some mole grips on the stud and got it off.

Yes you're missing something :)

It's definitely spinning. I'll have another go tomorrow as a mate is coming over to help get the engine out.

Ffs so the c***s at Renault decided on fitting a stud with a round head you can't stop spinning. French...

The subframe is hanging off, the only part still holding it on is the rack but I can't see where the rack bolts to the column. I thought it was the 13mm nut under the rubber gaitor on the rack by the bulkhead but I can't get that off because the stud spins and there's no way of holding it. So I...

Llandudno Garage is where I take mine for work. They have a time served RenaultSport mechanic there. They don't have all the stuff to do alignment though.

Dci had both a 2.75 and 3.25 rack. I got lucky. Within this thread somewhere are the part numbers for both racks.

AJK motors in Llandudno Junction have all the gear but no idea. I go to Buckley Tyres, there the closest place to me that know what they're doing.

http://www.armaspeed.com/eng/goods.php?act=cat&no=53

Is that on the MX5?

I'd run as per your drawing but the 1/4" lines should be 3/16" and the 3/8" should be 1/4".

I needed two clamps on the bottom hose on the rad for it to seal properly.

You drove it?! Does it run ok?

What a shitter, that's awful news. I've pmd you a proposal.

Yes

ebay, panel suppliers, local garages/spray shops. Didn't try Renault as I'd thought the cost would be extortionate

I think there around £20. Put a post up in Renault Wolverhampton under traders for one. Weight lol! They're about a gram!

Yeah that's where I nearly had a moment doing a ton. Kept it planted :) I can only imagine what happens if you lift off there...

Yes I believe so, I have pictures of the hi spec kit under 2118 from someone else on the forum and Dan@SJM runs his wilwoods with 300mm scenic discs under 15s.

Get a 182 exhaust trim, you'll need to cut it slightly bigger but the trim makes it smaller again and looks tidy.