Search results

nope the ECU controls boost

I'm behind with the times now, Is a clip clone still the way to go for a DIY Renault guy or are any of the above a good alternative?

Agree with that in regards to the mk2, its just a shame the common issues are so... common - And pricey! HOWEVER, I still stand by the opinion my 220 Trophy was the BEST RS car I've owned! - it took me a few weeks to gel with it but id recommend anyone who likes an RS to try one, as in buy one...

You could, but given the bad experience of people who have done that before i would make sure you do your research and make sure the local place is clued up enough to do the job, just because "its only a Clio" or "they do stage 6 fiesta STs" I would be wary of having something custom like this...

I assume the 197 timing tool your referring to is a custom tool to fit 197 cams?, not a Renault 197 tool as the horseshoe is the same for both?

Yes it has a factory intercooler but not a very big one, behind the grill on the drivers side. The problem is that the factory injectors are almost maxxed out even as standard so its not a great idea remapping one on the standard injectors. If it was me i would take it back to where you got it...

Finally back together, I hadn't ordered the camshaft seals, but the exhaust one was weeping slightly so I changed them, so that was a delay. I couldn't get the crank sprocket off (if I knew it was keyed I wouldn't have bothered taking it off!!!) so had to use a bit of heat so wanted to change...

have you stuck the alternator part no into eBay? the one failed on my DCI80 and when I googled the number I found out it was still used on some modern Renaults and got a date stamped 2014 genuine one that was identical from a breakers.

Its that long since I've been in there I'm not sure!

Since everything has been out for a cage id be pulling the dash top off and checking the earth points first

looking good mate!, telt ye you would like it! My mates 59 plate one had a tiny bit of rust under the rear wiper where the window meets the boot lid, he chanced his luck with Renault under 12 year anti corrosion warranty a couple of months ago as he didn't have dealer service history, went in a...

id imagine its all the sensors via the ABS pump as when the electrical side of my pump failed I lost the speedo

Just got the wheels back from a refurb, 4x PS3s fitted and I've sent the front calipers away for a rebuild and refurb in silver as they were binding on slightly.

I use them too, no issues.

Just finishing up on my 197 cambelt change, I had to use a bit of heat to remove the crank sprocket so am replacing the crankshaft oil seal. Now I believe this has probably never been done on this engine, but when I removed the plate that the seal goes into (not sure what its called?!) to get a...

I done it on a DCI years ago as I was a young lad and got stuck at the captive nuts on the subframe! - wouldnt be in a hurry to do it again! either drop the subframe or pull the engine with it if you must come out the top.

Trying to understand this a little better, So the original issue wasn't that it didn't work, it was that the fan stayed on 100%? no matter what speed the switch was at? Is it Climate control or manual heating?

I'm a tight c**t and charge it in the morning at work, and my power bank and then my power bank chargers hers at night 😂😂

Wrong amp and speakers then 😉

I'm doing the belt on my 09 197 this week, looks original to me, genuine idlers and tensioner, genuine water pump too. Given the lack of history with the car I don't believe it will have been done before. belt looks in good condition! was timed up spot on too. - The aux belt was ready to snap...

one of the lads at my old work had a sealey box with all the sealey tools and they seemed pretty good, the rep was in once a week too and just swapped anything that was broken

I keep bidding on the sandero access with the black bumpers and steels when they come up on eBay but they keep going for way too much!

You know your a car guy, or a Renault car guy, when you remove your own wheels to take to the tyre garage as you don't trust anyone not to bend the jacking points..........

Stunning, i love AG!!

Awesome, if there was ever a time for a Trophy then that it is! This was mine, 7 years ago, the morning after my bird told me she was pregnant and it felt like she had ruined my life! - It took all my worries away for a few hours! - The car is long gone and my not so little 7 year old turned...

Thanks lads!

I've never heard a sound bar I've thought sounded decent, but I suppose that's the point of them, compromised, neat and tidy. Amp and speakers all day for me.

Ive got this: Sealey TBTP10 Brake Service Kit Tool Chest Tray Wind Back Piston Spreader 42 Pc 5051747925137 | eBay A lot of kit for the cash

In the middle of my first F4R Cambelt, and I'm positive I read someone on here a while back (@Brigsy comes to mind?!) saying they go OVER the torque setting for the dephaser and exhaust cam nuts. I've had a search and cant find anything so I'm now doubting myself :ROFLMAO: