Search results

Have you tried Konis? I've had both new cup shocks and Konis in conjunction with a complete suspension and steering component overhaul. The Konis offer the better ride and in more ways than just compliance.

They do. Part number 47-217706 with 60mm spacing

How do they compare to ASTs on track?

This ^^^ If you wanted to keep costs down it would be GRP with a gelcoat.

How do they compare to other setups you've had/got?

v16daf

Re: 1M Akrapovic Flaps closed around town, open them up when the road does the same. Get one!

It's been covered a few times. Toyo R1R or Federal RSR. You could try the new Nankangs too, I'd expect them to be ok.

As chip has said. Ph2 with speedo drive, I have the same.

It's ecu pin 65. Btw does anyone know what pin it is for the ph2? I've got a gen90 ecu so I don't have my shift light anymore :( not that I need it but I'd like it working.

They are, but that's one of the downsides in that the bars are close to your head if you had a bump and no helmet. I'd rather a non-dash dodger so the bars follow the frame of the car.

Thanks Mark If Mark's happy with that I'll upload them to PB.

Could I trouble you for some photos Mark? It would be a great help.

I don't want a dash dodger though, I want something that fits nice and close, the SD one is designed around the interior so I'd have to have it out of the car and store it somewhere. Then refit it when I need it. If I get the CC Club cage then I can leave it in and just bolt the rear stays in...

That's good. I'm going to be getting a custom cages club cage (the main and front hoop) then make some removable rear stays and door bars. How does it fit down the b pillar and the two hoops? Is there room to keep the headlining? And if the seatbelt mounting points are spaced out I could keep...

Wish I'd have known this before I got the BP270s.

Anyone? MG cup Morgan does tour cage go through the dash?

Get the Bilsteins, get it corner weighted. Job done

AdamR had the AVO on his cup and had issues with bits seizing.

The corrosion protection on the Bilstein and H&R is pretty good. They are a quality product if your not fussed about damping adjustment and just want a nice firm ride that isn't crashy.

No problem! Try the Torques shop on eBay, they have a lot of adapters. Good stuff! I only asked as I thought I saw the car in your avatar at Oulton in the trackday trophy.

In terms of bhp per £ the pipers are best. Unless you can find some used 421 or engine dynamics/shrick cams Kent don't do them for the 172

When fitting a roll cage which goes behind the dash do you lose anything like vents, tweeters etc. and is there anything that needs relocating such as wiring or fuse boxes?

Rear are M10*1.00 front are M12*1.00 As for the callipers, they are all M10*1.00 Btw are you in the MSV trackday trophy?

I've got one and a new o-ring for it.

I'm guessing you're running Piper cams? What did it make at EFI?

I'd imagine the yozza to be louder and higher pitched because it has a smaller round silencer.

It was a little lumpy but it's better now it's on itbs so whether it was more an issue with the idle valve or not I don't know.

Nearly there! :D

Lovely graph!