Search results

Do you know where i can source this fluid or its title ? Does the system have a filter ?

Hi there I just done a track day in the 182 and it was faultless except the steering. When I was returning through the pit lane the steering was noisey like it was low on fluid ? Checked the level and it had blown a small amount out the top of the cap ? Cleaned it off and ran again exactly the...

Perfect thanks. See I knew someone would know lol

Does anyone know where I can buy new interior plastic trim ? Like the door handles with window control and inner door handle surround ? Mine are awful surely someone sells them ?

I made 2 files on my desk top 1 = old ecu 1 = new map. When you receive the email from Henk download the files and save the attachments to your new map folder. Connect your Rstuner go to the "about" screen top right corner. Select "unlock vci " enter your 8 digit code. The vci should now be...

Ok it's all done turns out I'm as dense as my wife says !! It's actually quite easy but written to be over complicated in my opinion. All that aside what an incredible mod ! So pleased.

Ok Henk emailed me this morning with the unlock code ! 1 bit sorted ! Now the calibration he sent me is a download not an attachment ? So when I save that download to a folder and select it via the rstuner there's nothing there ? Is that because I haven't downloaded it and saved it ?

I've got the email but it says don't open them unless through the rstuner and The one that doesn't say .cal doesn't open or have an 8 digit number ? Is there anyone in hampshire that can help ?

Ok but it says enter your 8 didget unlock code for the vci ?

Hi all hopefully someone can help. I have purchased a 2nd hand Rstuner. 1x Unlock code 1x 98ron map. Henk has emailed me the downloads etc but i cannot open the files. The only way it says to open them is to use bump ? So how can i find my 8 digit unlock code ? let alone map the thing ...

For what it's worth I'd pop a plug out and see what you've got ? I had some nasty motor factor part in mine and replaced it with the proper ngk part and there was a hell of a difference.

Thanks. I'll give him a ring. I'm just surprised it would drive fine and still have some 5k kick if the timing was out ?

Don't say that ! Done @ 75 not sure who by on 92 now ? Is it common for the timing to slip ? I know it had the dephaser pulley done at the same time ? Any garages that could check that in southampton area ?

Got the car a few months ago with a blowing exhaust and eng light on. Repaired exhaust with new hangers clamps etc. Fault was lambda bank1 but broke the other when I dropped the cat. Replaced both sensors with proper Bosch part. Cleared faults drives perfect for a while then looses power not bad...

Hi I'm fairly new to these but already I've learnt they have to have proper plugs ? Leads and coil packs fail also ? Have you had any warning lights on ? Worth getting codes read ? Pretty sure it wouldn't need a re map for a de cat.

That made me laugh knuckles. Glad I'm not going mad. Heard a lot about this 98ron map does it help to run them on vpower anyway ?

Hi all firstly I'm new but love this website ! it's my 1st 182 and I'm hooked but I'm finding my feet so I'm after some advice. When I initially start my car for the 1st mile sometimes even less it feels like between gear changes (normally 1st to 2nd) the engine brakes ? Literally like the...