Search results

meguiars gold class shampoo. Not sure if thats any good or the problem?

Does anybody use a water de-mineriser when washing their car. An inline one that connects to the hose pipe. If so are they worth it? as i live in a hard water area and it always leaves streaks when washing the car. Any recommended ones would be greatly appreciated. Thanks, Mark

Great thread I have read most of it whilst waiting for a flight. The longer megane scenic shifter. What age is that off or do you have a part number? You have inspired me to rebuild my clio currently sat in the garage needing some TLC

Looking to do a suspension refresh on the front shocks. Replace the wishbones, track rod ends, ball joints etc and all bolts at the same time. Can someone post up the dialogs page with the parts for a clio 182 ff Many thanks,

Hi i have a clio 182 with cup pack. The traction control light is up and it says service. I assume this is a ABS ring probably cracked?? What number of teeth does it have on it and is it wider than the standard one. Unable to jack car up at the moment to check. Thanks, Mark

which ast's are these?

thanks for all the comments. Does the yanoo kit basically replace the oem ball bit or is there more to it than that? or can you get different variants of the kit. Ill pm yahoo thanks.

What are people thoughts on the yahoo shifter or the pms one. Also where do you purchase the yahoo shifter? Thanks, Mark

My clio is in need of a new clutch. The car is currently my second car and is garaged. Its main use eventually will be for track days and spirited drives. What is the best clutch to fit or would you recommend OEM? Also whilst the box is out is it worth getting it inspected and roughly how much...

Where did you get the switches from in the end. Rswww? Looks good.

Will the 172 indicator stalk/ horn work on the clio 182 without any wiring mods and work? I have purchased a aftermarket steering wheel without the horn button. Thanks,

ok thanks for clearing that up! oops

I am in the middle of changing out the auxillary belt and tensioner on the clio. Checking for play in the bearings i found the air-con compressor pulley will spin around on the shaft without actually driving the compressor. How do i tighten this up or is it u/s now?? Pic below of compressor...

Looks great. must of took you some time!

I think the top right pic is the horn cover. Passenger side front

sold on amazon as well

just found a blown fuse in the engine compartment. Will replace that and hopefully it will sort it!

I have recently just fitted a new rad and fan to the front end of the clio. What temperature does the fan switch on at? Also when connecting the RS tuner up to the car i get a fault: - Cooling fan 1 relay on activation Anyone any idea what that is or how to fix it. I tried to run a actuator...

http://www.ebay.co.uk/itm/290927429787?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649 clio 182 rear caliper set. see ebay link

Thanks a lot

Does anybody know the part number for a new thermostat for the Clio 182. The gauge on mine is reading a little high and the stat hasn't opened up. Also the price please.

Do you have to turn the heaters on full to open up the heater matrix too? When warm.

I have removed my rear brake calipers for overhaul and refitted them but cannot get them to stop leaking when pressuring them up from the hose. Can anyone shed some light on what i am doing wrong! I have tried tightening them as tight i can. Do the flare fittings seal again once split? Thanks, Mark

I have found that the brake bias adjuster clip has broken off due to the arm seizing. Can someone help me out please by telling me the part number for the clip. The renault guys can't seem to understand the picture. See attachments. The hole seen on the bracket from the rear axel is where it...

Does any body know if a copper washer is fitted on the end of the hose. Just wondered as some calipers use them

the flare is a renault part. Is it not the flare that seals onto the bottom face. The threads looks a little bit corroded but i thought that it was the face that was important to seal it. I tightened it past the point of resistance first then a bit tighter till very tight and it still leaked..

I have just fitted some overhauled rear clalipers. When i fitted the brake line fitting and primed the system it leaked through the threads. I replaced the brake fitting and it still leaks.. I checked the face of where it seals and it looks clean. It just won't seal? I tried to fit it three...

big red just refurbed my rear calipers and i got them all done. They look really good. I would go for the seal kit if i didnt want them painting.

i have found a company on the internet to repair the rear calipers as a pair. Bigred.co.uk £139 to overhaul and powder coat and renew all seals pistons etc. I started removing the caliper last night. How does the handbrake cable come out of the caliper. Does it need uncoupling underneath the...

I have had my car in the garage over winter and have not driven it for some time. I went in the garage after the cold spell and there is brake fluid all over the garage floor. It appears the seals has failed on the onbe of the rear brake caliper and dumped it all over the floor. I can't...