Search results

Indeed it is :):) Even with the tensioner retracted its like the belt is 2 inches to short!!!! Ive made a tool for doing mine..... but do Renault actually have a tool for this..... ive never seen one or a copy listed.

Give the battery a good charge.....& see how it performs, if you've only just bought the car.... the battery's condition might not be great. Also the 6 month old one u say u put on.... did u charge it first?

All the oil's you listed are fine for it. Also.... u hearing the whinning noise only when moving??

Why are u doing this???

Indeed it does sound like a weak battery. Also.... on the clio's..... when u initially crank it over, & the battery's weak.... it will crank for a few seconds.... but if the battery is that low the ignition relay switches off & kills the starter. This also happens if the car cranks for a while &...

Don't have to use clip...... but any advanced Diagnostics that can log into your car & give the info you need :)

If pedal was rock solid... either you are loosing the Vacuum to the servo..... or you have a faulty ABS pump & the solenoids are possibly jamming in it, causing you not to have any pedal movement.

Well as you say its a new battery..... you now need to look at a possible charging issue...... or a draining issue when the cars stood. As said check the voltage across the battery terminals when the engines running.... should be about 14.4 volts. Also.... ive had alternators where they will...

Problem with reluctor rings on the rear disks.

Sounds like a classic misfire...

went for the 280 dude. just waiting for it to arrive

Im doing mine when the kit arrives from Engine Dynamics!!!

Could possibly be the electronic throttle body gone faulty....... this wouldnt have caused that huge bang though you were talking about. Seeing as the revs are up & down.... you could do a visual check on the butterfly flap in the throttle body, by taking the air intake pipe off.... & just see...

quite simple really.... the seal is leaking........ maybe go back to your gearbox builder & get him to change it. tis possible the seal got nicked or damaged when putting it on.

Ive had 3 karcher's in about 20 years..... first one went for about 15 to 16 years before needing a repair.... similar fault to what happened to yours... mine popped a valve..... anyway somebody borrowed the machine without me knowing & killed it. So they replaced it with an entry level...

The code can relate to either the coil pack or indeed an in injector. Got a coil pack you can borrow?

Tell him to listen for the compressor kicking in & out..... i doubt that it is. Does the heater fan work okay controlled via the buttons etc??

I doubt the system is actually on even though the light is on. So is it blowing freezing cold air??

No wont fix it.... but just to turn it off for the time being. U sure its on permanent?? Can you hear the compressor kicking in & out???

Jump underneath it & disconnect the plug that runs the clutch on the end of the Aicon compressor... aircon will go off.

check ya timing dude :)

Ya nearly there chip. You must know in the back of your mind whats wrong with this car. Nobody's mentioned to have checked in the whole post either. Low & behold....... upon me posting Tunst... has mentioned it :)

This is correct :) Just need to lock the crank in the correct position with timing pin.... pop camshaft rear oil seals out.... look at the cams see if you can see how far out they are.... also the camshaft timing tool wont go in if so. Reset the cams....... & using the correct tools...

That tool you saw him put into the cams.... is probably the only bit they they had. There's more tools for the timing belt job on the F4R. To do it correctly anyway.

A new master cylinder.......

as title

no probs :)

soon as all 4 wheels do a complete rotation of matched wheel speeds.... the lights will go out.

Thats why your ABS lights have come on.... as the rears were not spinning the system thinks both rear signals are missing. Soon as its back on all 4's.... & u drive off they will go out. :)

On axle stands?? have u been running it with the front wheels spinning up in the air?