camber

Hey guys i looked a lot here in the forum what top mounts are working with the Bilstein B14? i heard that there are top mounts you weld in? i dont wanna weld the top mounts in so i wanna get some i bolt in. and i would like to still use my OMP strut brace. Maybe its the easiest way to get the...

Hi everyone About to purchase some bushes for my 172 cup. I’m looking at the powerflex black series and the purple ones. Is the black really that much better?

Hi guys I’m currently building my Clio 172 cup for track days at knockhill and I’ve just bought camber bolts and camber shims. how much camber / toe are you all running? any help appreciated

Hi guys just to double check if this is the correct camber bolts for the cup. Also, how do I go about cambering the rear? Thanks!

Right then, alignment boffins! I have these reading for the rear of my 2011 clio 1.2 (fixed rear axle) and im wanting to pull the OSR camber in by 1 degree and push the NSR toe out 0.4 degrees. Looking at a conversion table by trackace (...

Hello everybody! I bought my Clio one year ago.The car had all in original. I fell in love with this Renault. Something about car: Renault Clio 2 ph 2 Dynamique engine: 1.5DCi 82HP year: 2002 First mods: (end 2015- september 2016) -new suspension COILOVERS :TaTechnix -rims: MOMO Tens 15inches...

I think this one might have come up before... How can the camber be adjusted on the front of an RS Clio 200? There are the odd sites selling 'clio 200 camber bolts' - but they just look like the universal powerflex items ( here). It does say "This fits 2 bolt hub to strut models only" - whether...

Just fitted my camber bolts and had them dialed in to -1.5 deg. I'm now thinking the inside edge of the tyre might be too close to the suspension spring, especially on track under hard cornering. I can just get my fingers in the gap between the two, so say roughly 10mm +/-. Is that enough...

Alright guys, finally got round to sorting out a little project thread on here for my malaga orange 1.2. This is my first car so i dont want to be throwing loads of money at it. this is what it looked like at stock So the first thing i did was get some alloys, they were cheap and i fancied...