1.2 to 172 sport interior question

[MDP91]

After fitting my 172 interior into my 1.2 yesterday I noticed the airbag connectors are different under the seat. This means that I now have my airbag and service light constantly on. Can anyone suggest a way to turn these off?

Mark

 

[AlexCrosbie]

unplug the wires to the lights

 

[SimonR.]

3.3ohm resistors in the connectors then you will need to reset the lights on the ecu with a clip

 

[MDP91]

3.3ohm resistors in the connectors then you will need to reset the lights on the ecu with a clip

Okay, how do I reset the light?

 

[Anton/ClioSportRep]

You got the clips in the right way round? Had this when I installed my 182 ones.

 

[MDP91]

You got the clips in the right way round? Had this when I installed my 182 ones.

What do you mean? I'll get some pics up

 

[MDP91]

As you can see one of the wires does fit and clips in but I have a brown wire which I assume is the seatbelt and a smaller blue connector. The larger connector on the left is from the seat, which I assume is the 172 female connection for the seatbelt?

 

[Anton/ClioSportRep]

You see the box with the yellow on it on the right? Connect that to the box on your left.

 

[MDP91]

You see the box with the yellow on it on the right? Connect that to the box on your left.

Wont fit mate, completely different connections.

 

[MDP91]

Any way I can take the male connector from a 172 and re-wire it to fit my Clio?

 

[Sparky]

I rewired it and it worked, can't rember specifics

 

[MDP91]

I rewired it and it worked, can't rember specifics

What did you do, cut the male connectors out a 172 and re-wire them into a non-sport?

 

[MDP91]

All sorted. Just put a couple of 3.3ohm resistors in the airbag connectors.