182 front ABS sensor removal

[Dredd]

I need to remove a front ABS sensor from my 182 and would really rather not remove the hub if I don’t have to. Tork T30 screw is out and I’ve had a quick go at it with a hammer and chisel but its not budged. Is it possible to do without removing the hub? I have a new sensor so don’t mind if it gets damaged whilst being removed.

Thanks,
Dave.

 

[hipwell]

If it's anything like the rears then it ain't coming out without destroying it.

I had to drill mine out and then chisel then outer metal casing out.

Never tackled a front one though

 

[JamesBryan]

Yeah the front one on mine that I changed needed hitting from the other side and drilling iirc.

 

[Dredd]

Pretty much destroyed it with a couple of chisels then found out my drill is knackered. Couldn’t be arsed to take the hub off so garage is sorting it tomorrow before the MOT.

Thanks,
Dave.

 

[Kermit the Van]

Is the problem with removing them the age old problem of components being fitted minus Copperslip ?

 

[bozothenutter]

Is the problem with removing them the age old problem of components being fitted minus Copperslip ?

This, and the hole being nearly a interference fit.
Light sanding with some rolled up sanding paper fixes that.?

 

[PP200t]

I managed to do mine on a 172 without removing the hub. I smacked the top bit off with a chisel and hammer and then drilled it out. Worked a dream and the new one fitted straight in. Did the sandpaper trick on it as well.

 

[YorkshireKyle]

Best thing to do is heat up the torx bolt, grind 2 sides flat, leave it soaking in WD for a half an hour and work it out with some molegrips. Saves messing about and lots of swearing