182 Geo help

[jassa]

Hey all,

I had some new tyres fitted last week, and thought I'd get the geometry checked while I was there, and its all over the place. What should the values be? The car has Eibach springs on Cup dampers.

I assume Eibach front camber bolts would be a good place to start?

 

[jassa]

Also, any recommendations for where to take the car to get the geo done properly.

 

[JamesBryan]

Definitely needs camber bolts.

The rest isn't too bad. Could shim the rear to get the camber a bit more even if you wanted.

Where abouts are you?

 

[jassa]

Definitely needs camber bolts.

The rest isn't too bad. Could shim the rear to get the camber a bit more even if you wanted.

Where abouts are you?

What size shims would you recommend?

I'm in Bexley, which is Greater London/North West Kent border.

 

[Martin.]

As said, camber bolts and adjustment on the front would put you in a much better place. The rest isn't too bad. Most rear beams are all slightly bent.

You could add a camber shim to the NSR to make it nearer -1.53 on the other side.

 

[JamesBryan]

What size shims would you recommend?

I'm in Bexley, which is Greater London/North West Kent border.

A 30 minute shim would get you close.

I don't know where to recommend, you're miles away from me.