ABS issues

[205gti6m3clio172]

Does anybody know if I can recode my cars ECUs so that I can run it with no ABS? By cutting the power to the ABS module, it obviously loses the ECU from the canbus network and therefore will register a fault with other ECUs. But can I recode the other ECUs to not require communication with the ABS module, like in a cup (non-ABS) car?

 

[da rok]

just unplug the fuse when you want to have some fun... at least you will still have abs the rest of the time...

 

[205gti6m3clio172]

But by removing the fuse the other ECUs lose communication with the ABS bringing on warning lights etc. I was looking for a permanent non-ABS solution. Like the Cup cars have

 

[RichieJA]

Could it not be mapped out ?

 

[205gti6m3clio172]

That's my question. The other ECUs will be the same as the non ABS cars, so surely it's just a question of rewriting them to not look for communication with the ABS?

 

[RichieJA]

Pretty sure henk from fastchip could do not or anyone good with code

 

[da rok]

in that case as above... get the ecu re programmed

 

[bloke]

not done it but assume you can just reconfigure the uch? can obviously cause issues though if you have a late 172 or 182 that takes speed from abs ecu.