After market steering wheel.

[rollerdan]

Ive bought a Oreca steering wheel id just like to know how to wire the horn up and the resistors to keep the air bag light off . Ive seen the guide to just replace but its does not tell you about the resistors and the horn wiring .

 

[Will.]

I gave up and bought a ph1 indicator stalk with a horn button on it. Much better.

 

[Fletcher]

I gave up and bought a ph1 indicator stalk with a horn button on it. Much better.

I did the same..

 

[rollerdan]

How hard isit to wire up the phase 1 stalk?

 

[rollerdan]

Anyone?

 

[Glenn182]

2 screws and a connector mate, piece of piss believe me.

For my airbag i used two 3.9ohme resistors.

 

[rollerdan]

Okay dude i dont understand where the resistors go? Can sumone show me a pic really need help here !

 

[rollerdan]

ive been doin some research on the resistors to turn the air bag light off. i cant figure out where they go ? do i need 2 resistors to put into each plug ? am i right in thinking there are two air bag plugs? then just put one resistor in each plug connection then thats that sumone please help...

 

[1812lsd]

http://www.cliosport.net/forum/showthread.php?439996-Aftermarket-steering-wheel-fitting-guide

http://www.cliosport.net/forum/showthread.php?328167-Removing-Mk2Ph2-Steering-wheel In pic 1, the 2x yellow plugs are the ones you need to place the resistors into!

http://www.cliosport.net/forum/showthread.php?500121-Sabelt-Steering-wheel-Cruise-Control

http://www.cliosport.net/forum/showthread.php?422979-After-Market-Steering-Wheel-and-CC

The resistors you need from Maplin are the 3.3ohm ones (Worked for me) The Maplin product code is M3R3, they are 24p each.

If you are using the OMP/MOMO centre horn push, do not put the live to the centre connection as it will short on the wheel.