RB 182
Just tried to fit some rear aftermarket dampers to the gf's 182 and they dont fit! 
Standards use an M8 Nyloc at the top mount but these are M10x1.0 bloody fine pitch... Is this normal for non genuine dampers? I was thinking of sticking the bushes on the lathe to open them out but they will probably be to fragile. Anyone else had this issue before?
Standards use an M8 Nyloc at the top mount but these are M10x1.0 bloody fine pitch... Is this normal for non genuine dampers? I was thinking of sticking the bushes on the lathe to open them out but they will probably be to fragile. Anyone else had this issue before?
