are these acceptable?

[Šįk]

http://cgi.ebay.co.uk/Hubcentric-Wh...2:1299|66:2|65:12|39:1|240:1318#ht_1436wt_909

yay or nay?

..to fit a 2002 ph2 172?

thanks

 

[Šįk]

any1 recommend them or recommend not to get them due to s**t quality? are they good to go for!? will they even fit the 172?.... common guys!!

 

[Addz]

I dont see how they can be poor quality to be honest, just a chunk of metal with some holes in it!
as far as i know all 4 stud clio's are the same centre bore i think

 

[Chrisjk]

I have them, good quality, all round a solid bit of kit.

 

[drhowser]

should be fine,

only question is what wheels are you looking at using them with? you won't be able to go far past et37 without risking rubbing.

 

[Šįk]

should be fine,

only question is what wheels are you looking at using them with? you won't be able to go far past et37 without risking rubbing.

just keeping the standard 172 alloys, that should b fine shouldn't they?

 

[drhowser]

i can't remember exactly the offset of them, 46/47 i think?

that would give you an effective offset of 21/22 which i am pretty sure would rub.

basically, the lower the et value, the further the wheels will stick out.

to give you an idea, i was running some wheels at et37. with 45 profile tyres they were fine but with 50's they would rub on a big compression.

 

[sandy]

ye they will be sweet pal, will look much better as well. the only thing you will need is longer wheel bolts!!

 

[Chrisjk]

ye they will be sweet pal, will look much better as well. the only thing you will need is longer wheel bolts!!

No, with these you use the origionals plus 4 smaller ones to hold the spacer to the hub.