Right well I first had a problems after the car ran out of fuel, and didn't get topped up for a week. Ran on only 3 cylinders at first, then I replaced an injector, and after that it started running on two cylinders. I've just put a whole new rail in with injectors and still the same. I've changed the leads and coil pack also, no change. I have a lambda in front of me but I seriously doubt it would be that.
I did notice that whatever plug is in the middle on the front of the block has a connector with 2 wires entering it, yet there seems to be a third wire that's been cut and is just poking out the heatshrink above.
I've ran out of ideas other than the ecu, and I don't want to be changing that.
Any ideas anyone? Whoever comes up with a winning solution will have a case of beer posted to them!
I did notice that whatever plug is in the middle on the front of the block has a connector with 2 wires entering it, yet there seems to be a third wire that's been cut and is just poking out the heatshrink above.
I've ran out of ideas other than the ecu, and I don't want to be changing that.
Any ideas anyone? Whoever comes up with a winning solution will have a case of beer posted to them!