clio 172 suspension on a 1.5 dci ?

[reverand]

Hi I was wondering if I could fit clio 172 ph1 shocks, springs , hubs wishbones etc to a 1.5 dci ph2 5 door. Basically I have a 172 which I have to stop using for a couple of years due to young kids and misses out of work. This means all the parts are sitting there and free ! Would the rear axle bolt on ? Any advice would be great.

 

[Dan@SJM]

Yes. You'll need the driveshafts too

 

[reverand]

So the drive shafts will go in the diesel box ok? And will the wishbones need swapping as I think the roll bar is different and would like to keep the diesel one

 

[Gray]

You will need the below parts from a 172:

driveshafts
hubs
ARB
discs, pads, calipers, flexi lines.
F+R shock absorbers
F+R springs

And that's it.

We did the conversion on ph-reebones Dci last year... The only issue we found was the Dci and PH-1 172 ABS sensors used different connectors.

 

[reverand]

Great thanks for the help !

 

[boom]

You will need the below parts from a 172:

driveshafts
hubs
ARB
discs, pads, calipers, flexi lines.
F+R shock absorbers
F+R springs

And that's it.

We did the conversion on ph-reebones Dci last year... The only issue we found was the Dci and PH-1 172 ABS sensors used different connectors.

is it possie to swap the wishbones aswell?