clio management

[Nafoff]

i know there is Omex

but is there any others to look at???

 

[Guppy]

Omex is good so i hear?

And local for yourself

I no the Peugeot/Citroen boys use KMS aswell but have never seen any Clio's running it?

Not to sure dude but perhaps the tried and tested route may be the best??

 

[172Ben]

Emerald, used it on the metro, very good imo for the money

 

[Icarus]

i know there is Omex

but is there any others to look at???

Motec M400, GEMS EM36, DTA S40, SC Typhoon, Autronic SM4........ for a start.

Cheers
M

 

[Nafoff]

cheers guys, will look into them all.

matt - tried emailing you at your new address

 

[Ali]

So jamsport not provide a soloution?

 

[Sean.]

yeah they use gotech. good on the fords by all accounts.

 

[Nafoff]

another to look into then

 

[Fred@BTM]

neil you'd be proud, i bought fastcar today! very good btw! (bit too much euro **** though, that bird ain't bad either!)

anyway, give me a call/e-mail

 

[crossflow]

Can you just pull the standard ecu out of the car and replace it with an aftermarket type???

 

[Schweppy]

Can you just pull the standard ecu out of the car and replace it with an aftermarket type???

No need new wiring loom with different sensors, etc.

 

[crossflow]

Don't understand so your saying that you can pull the standard ecu out and it won't affect anything like warning lights or that

 

[Fred@BTM]

its a bit complex ie keeping the oe dash, loom etc etc etc

if the car has a UCH, multiplex milarky then its easier to piggyback the aftermarket into the existing setup, if you're clever no warning lights will be present

note - i don't do wiring or ecu's for a reason as you can guess!

 

[Sean.]

fred is correct, you have to kep the std ecu to run the dials etc, that its only real function, the aftermakret one does everything you need it to engine wise.

 

[Fastchip]

Most important is not the brand ECU you use, but the installation and calibration.
Make sure you use someone with lots of experience.

 

[crossflow]

So if i pull oem ecu out i will lose the dials thats not too bad can connect the rev to the aftermarket ecu, does the speedo fuel and water gauges go through the ecu, or am i better pulling the whole dash out and replacing it all??

 

[Nafoff]

neil you'd be proud, i bought fastcar today! very good btw! (bit too much euro **** though, that bird ain't bad either!)

anyway, give me a call/e-mail

good work sir, charlotte is truly awesome yes, i said it in my MOTM....
there is a lot of euro but thats whats happening at the moment..

pm sent btw