LY 182
anything common on these causing a hesitation from low revs?
checked all the loom all seems ok, has had a new map sensor on it recently
came up with the following fault codes -
fuel circuit
pre cat lambda sensor signal
put it on the gas anyliser its running lean (co-0 hc-1 lambda 1.03)
lambda likely to cause this?
funny thing is i cleared the codes and it seems ok-- not going to look untill tomorow but any ideas appreciated
cheers
checked all the loom all seems ok, has had a new map sensor on it recently
came up with the following fault codes -
fuel circuit
pre cat lambda sensor signal
put it on the gas anyliser its running lean (co-0 hc-1 lambda 1.03)
lambda likely to cause this?
funny thing is i cleared the codes and it seems ok-- not going to look untill tomorow but any ideas appreciated
cheers